Hornet Car Security 700T manual door lock learn routine

Page 20

door lock learn routine

NOTE: Failure to insert the diodes at the correct point will allow the system to be disarmed by one of the power door lock switches inside the vehicle. The best place to insert the diode is at the keyless entry module itself or at the relays.

door lock learn routine

Before the unit will respond to the factory remote keyless system, it must learn the polarity of the door lock

wires. To learn the lock polarity:

1. Open the vehicle door.

2. Turn the ignition to the “on” position.

20	© 2001 Directed Electronics, Inc. Vista, CA

Image 20

Contents 2001 Directed Electronics, Inc. Vista, CA N700T Rev. E Installation GuideModel 700T table of contents Auxiliary Harness H2 Wire Connection GuideSystem Features Learn Routine Wiring Quick Reference Guidewhat is included installation points to remembertools required deciding on component locationsvalet/program switch control modulestatus LED optional starter kill relayobtaining constant finding the wires you needfinding the 12V switched ignition wire finding a + parking light wire finding the door pinswitch circuit finding the starter wiremaking your connections solderless butt connectionssolder connections primary harness H1 wire connection guide IMPORTANT! Never interrupt any wire other than the starter wireH1/1 H1/2H1/2 WHITE light flash output H1/3 WHITE/BLUE + trunk release/sensor shunt inputConnect this wire to the optional domelight supervision relay H1/9 YELLOW + ignition input H1/7 VIOLET + door trigger inputH1/8 BLACK - chassis ground connection the same point you connect the control module’s black ground wire auxiliary harness H2 wire connection guide H2/1 BROWN - horn honk outputH2/2 GREEN arm input H2/3 RED disarm defeat inputPassenger Unlock LockDriver’s Unlock connecting door lock inputs in vehicles with driver’s door unlock and external relays door lock learn routine plug-in harnesses on-board stinger doubleguard shock sensorinternal programming jumper light flash jumpersystem features learn routine system features menu TWO CHIRPS - PRESS8 NO FUNCTION troubleshooting table of zonesrapid resume logic Shock sensor does not trigger the alarmStatus LED does not work The Valet/program switch does not workClosing the door triggers the system, but opening the door does not wiring quick reference guide