Hornet Car Security 700T manual Connect this wire to the optional domelight supervision relay

Page 14

Connect this wire to the optional domelight supervision relay.

H1/4 BLACK/WHITE 200 mA (-) domelight-supervision output

Connect this wire to the optional domelight supervision relay.

IMPORTANT! This output is only intended to drive a relay. It cannot be connected directly to the domelight circuit, as the output cannot support the current draw of one or more bulbs.

H1/5 GREEN (-) door trigger input

Most vehicles use negative door trigger circuits. Connect the green wire to a wire which shows ground when any

door is opened. In vehicles with factory delays on the domelight circuit, there is usually a wire that is unaffected

by the delay circuitry.

H1/6 BLUE (-) instant trigger

This input will respond to a negative input with an instant trigger. It is ideal for hood and trunk pins and will

report on zone one.

14	© 2001 Directed Electronics, Inc. Vista, CA

Image 14

Contents 2001 Directed Electronics, Inc. Vista, CA N700T Rev. E Installation GuideModel 700T System Features Learn Routine table of contentsAuxiliary Harness H2 Wire Connection Guide Wiring Quick Reference Guidewhat is included installation points to remembertools required deciding on component locationsvalet/program switch control modulestatus LED optional starter kill relayobtaining constant finding the wires you needfinding the 12V switched ignition wire finding a + parking light wire finding the door pinswitch circuit finding the starter wiremaking your connections solderless butt connectionssolder connections H1/1 primary harness H1 wire connection guideIMPORTANT! Never interrupt any wire other than the starter wire H1/2H1/2 WHITE light flash output H1/3 WHITE/BLUE + trunk release/sensor shunt inputConnect this wire to the optional domelight supervision relay H1/9 YELLOW + ignition input H1/7 VIOLET + door trigger inputH1/8 BLACK - chassis ground connection the same point you connect the control module’s black ground wire H2/2 GREEN arm input auxiliary harness H2 wire connection guideH2/1 BROWN - horn honk output H2/3 RED disarm defeat inputPassenger Unlock LockDriver’s Unlock connecting door lock inputs in vehicles with driver’s door unlock and external relays door lock learn routine plug-in harnesses on-board stinger doubleguard shock sensorinternal programming jumper light flash jumpersystem features learn routine system features menu TWO CHIRPS - PRESS8 NO FUNCTION rapid resume logic troubleshootingtable of zones Shock sensor does not trigger the alarmStatus LED does not work The Valet/program switch does not workClosing the door triggers the system, but opening the door does not wiring quick reference guide