Harman Stove Company P35I owner manual I. Optional Log Kit, J. Optional Trim Kit- #1-00-00775

P35i Fireplace Insert

I. Optional Log Kit

Ceramic log #3-40-674099 Log Bracket Kit #1-00-774401

Remove the two bolts from the air manifold below the glass opening. Install the log bracket using the same two bolts. Place the log onto the bracket with the smaller twigs pointing back toward the burn pot.

Please Note; The decorative log is fragile and must be handled with care. The abrasive nature of pellet ash may cause the log to deteriorate. Therefore, the log is not covered under the appliance warranty.

J. Optional Trim Kit- #1-00-00775-*

The trim kit option includes a door frame and an ash lip trim. To install the ash lip trim, simply slide it over the ash lip from the front. You can secure it with a few dabs of high temperature silicone, if desired. To install the door trim, follow these steps.

• Remove the door latch
by loosening the small	Set-screw
set-screw and tapping
out the roll pin.
• Remove the door
by lifting it off of the
hinges. Lay it, face
down on a flat surface.	Roll Pin
• Locate and drill the
dimpled holes in each
corner of the door,
using the provided drill
bit.
• Install the trim frame with
the threaded studs through
the holes in the door, and
secure it with the four nuts
provided in the kit.

* Trim finish suffix; 4=Gold, 7=Brushed Stainless, 8=Bright Nickel

K. Service Rail Kit- #1-00-774125

The Service Rail Kit is used to support the insert body while it is pulled out of the mounting frame for cleaning or service. Used only with a raised hearth installation, it is easily adjustable to a height range of 4" to 14". Assemble the rail kit using the provided instructions. After removing the Ash Pan cover, the rails attach to the mounting frame with four bolts. There are even stop bolts on the rails to prevent accidental roll-off.

Two bolts on each side secure the rail kit to the mounting frame.

22 Pellets or Corn/Pellet Mixture Only 3-90-775 Save These Instructions