P35i Fireplace Insert
1Listing and Code Approvals
A. Appliance Certification
Model: | P35i Insert |
Laboratory: | |
Report No. | |
Type: | Solid Fuel Room Heater / Fireplace |
| Insert. |
Standard(s): | ASTM |
| ULC/ORD |
This appliance is also approved for installation in a shop.
B. Mobile Home Approved
This appliance is approved for Installation in mobile/ manufactured homes. The structural integrity of the mobile home floor, ceiling and walls must be main- tained. The appliance must be properly grounded to the frame of the mobile home, and must never be installed in a room designated for sleeping. The unit must have provisions for an outside air source when installed in a mobile home.
E. BTU & Efficiency Specifications
Particulate Emissions | Exempt from EPA per | |
Rating: | 40 CFR, Method 28A | |
*BTU Input: | 0 or 6,000 - 35,000 / hr | |
|
| |
Heating Capacity: | 1,500 sq. ft. | |
Hopper Capacity- | 41 lbs. | |
| ||
Hopper Capacity- | 62 lbs. | |
| ||
|
| |
Fuel: | Wood pellets / Corn† | |
Shipping Weight: | 289 lbs. |
*BTU input will vary, depending on the type of fuel you use in your stove. Moisture and ash content can affect performance.
† Corn is approved for burning only when mixed with wood pellets.
C. Glass Specifications
This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass if needed.
D. Electrical Rating
115 VAC, 60 Hz,
3.6 Amps
4 Pellets or Corn/Pellet Mixture Only | Save These Instructions |