P35i Fireplace Insert
6.Igniter
Vacuum to clean.
Whenever cleaning burn pot air chamber. To remove igniter;
•Loosen wing screws and remove cover on front of burn pot.
•Using a 5/16" wrench, remove the two black screws above the cleanout. The igniter and brack- et are now free.
•Slide the insert body out of the mounting frame.
•Locate the pale blue and yellow wires entering at the bottom of the feeder body.
•Remove wire ties as needed to loosen the igniter wires.
•Pull the igniter and bracket out from the front until the wire disconnects are accessible.
•When installing igniter, reverse these steps and be sure that the plastic coated wires are pulled all the way to the rear of the feeder.
•Re- tie all wires clear of all hot or moving parts.
This shows the igniter and bracket removed from the burn pot. Missing in the illustration is the wires from the igniter which run through the burn pot air chamber. Only the first few inches of the wires are insulated for high temperatures. These insulated wires are all that can be inside the feeder or burn pot.
FEED MOTOR
This hole in the feeder body is where the igniter wires pass through to the burn pot.
Save These Instructions | Pellets or Corn/Pellet Mixture Only | 37 |