Harman Stove Company P35I owner manual Addendum, P35i Fireplace Insert

Page 39
Addendum

P35i Fireplace Insert

Addendum

Minimizing Smoke During Loss of Power Using Battery Back-up

HarmanTM strongly recommends installing battery back-up to minimize entry of smoke into the room in the event of power loss.

Your pellet/biomass burning appliance relies on a combustion blower to remove exhaust. A power failure will cause the combustion blower to stop. This may lead to exhaust seeping into the room. Vertical rise in the venting may provide natural draft. It is, however, no guarantee against leakage.

There are two HarmanTM approved battery back-up options for your appliance:

Uninterruptible Power Supply (UPS) UPS battery back-ups are available online or at computer and office equipment stores. Your HarmanTM appliance with Rev E or later software available beginning in November 2010 may be plugged directly into a HarmanTM approved UPS:

The APC (American Power Conversion) model #BE750G and the TrippLite model INTERNET750U are tested and approved. Other brands or models may not be compatible.

When power is lost, a fully charged UPS will power a safe, combustion blower only shut-down. Your appliance will pulse the blower every few seconds to clear exhaust until the fire is out. NOTE: The UPS

provides safe shut-down only. It is not intended for continued operation.

Your appliance will recognize when power is restored. What happens depends on ESP temperature and whether it is equipped with automatic ignition:

In “Automatic” setting, units equipped with automatic ignition will respond to the set point and ESP temperature and resume normal operation.

In “Manual” setting or for units without automatic ignition:

If the ESP is cool, the appliance will remain shut down.

If the fire is out and the ESP is still warm, the feeder may restart. Since the fire is out, the ESP temperature will not rise. The unit will then shut-down, and may flash a six-blink status error. (See ESP error codes)

If the fire is still burning, it will resume normal operation.

Contact your dealer if you have questions about UPS compatibility with your appliance.

Harman Surefire 512H Battery Back-up The 512H connects to a 12 volt deep cycle battery that will run your appliance for up to eight (8) hours. It includes a trickle charge feature that keeps your battery charged when power is available. NOTE: If the power is out for longer than battery life, smoke

leakage may still occur unless your stove has been safely shut down.

CAUTION! Always keep appliance doors and hopper lid closed and latched during operation and during power failures to minimize risk of smoke or burn-back.

CAUTION! Use only HarmanTM approved battery back-up devices. Other products may not operate properly, can create unsafe conditions or damage your appliance.

Save These Instructions

3-90-775

Pellets or Corn/Pellet Mixture Only

39

Image 39
Contents SAVE THESE INSTRUCTIONS ModelDiscard Installed, a House Fire May Result TABLE OF CONTENTS A. Appliance Certification E. BTU & Efficiency SpecificationsC. Glass Specifications 1Listing and Code Approvals2Special Warnings and Notes SPECIAL NOTEA. Design, Installation & Location Considerations B. Fire Safety3Getting Started Glass C. Component LocationsP35i Fireplace Insert Hopper Lid LatchFire Risk D. Pre- Use Check ListP35i Fireplace Insert 4Dimensions & ClearancesA. Appliance Dimensions 60.96 cmand Manufactured Fireplaces B. Clearances To CombustiblesD. Minimum Opening for Masonry Masonry or Manufactured FireplaceF. Factory-BuiltFireplace Installation A. Vent Termination Requirements Vent InformationOutside Air B. Avoiding Smoke and OdorsNegative Pressure, Shut-down,and Power Failure Vent ConfigurationsC.Venting Requirements and Restrictions WARNING! RISK OF FIREWARNING! RISK OF INJURY OR PROPERTY DAMAGE D. Existing Fireplace Installation Non-combustible InsulationSealing Plate F.Optional Zero Clearance Cabinet Installation E. Existing Fireplace, Rear VentVent pipe seams must be accessible 6Mobile Home A. Mobile Home InstallationA. Outside Air Attachment 7Appliance Set-UpC. Routing the Power Cord B. Installing the SurroundE. Attaching the Venting D. Securing the Mounting FrameF.Installing the Body into the Mounting Frame G. Control Board InstallationH. Room Sensor Installation K. Service Rail Kit- #1-00-774125 I. Optional Log KitJ. Optional Trim Kit- #1-00-00775 B. Fuel and Fuel Storage A. Fire SafetyOperating InstructionsC. General Operating Information 1. ESP Exhaust Sensing Probe2. Circuit Board b. Mode Selection a. Feed Rate Adjustmentd. Blower Speed Adjustment e. Igniter Mode SwitchE. Draft Test Procedure D. Before Your First FireF. Starting a Fire - MANUAL J. Shut-Down G. Starting a Fire - AUTOMATICH. Maintaining the Fire I. Relaxation ModePossible Cause TroubleshootingError Message SymptomCAUTION! SHOCK AND SMOKE HAZARD Service & MaintenanceA. Shut-downProcedure B. Quick Reference Maintenance ChartC.General Maintenance Procedures By User 5.Cleaning Area Beneath Burn Pot Grate5.Cleaning Heat Exchanger & Exhaust WARNING! RISK OF FIREBy User 6.Inspect / Clean HopperSoot and Fly Ash Formation & Need for Removal 7.Cleaning the Door GlassBy User 8.Venting and Chimney SystemGlass D. Motors and ComponentsP35i Fireplace Insert Hopper Lid Latch1.Feed Motor 2.Combustion Blower3.ESP- Exhaust Sensing Probe 5.Feeder Body 4.Distribution Blower6.Igniter 11Reference Materials PLUG PIN 11 WHITEP35i Fireplace Insert P35i Fireplace Insert Addendum4 5 6 P35i Pellet InsertPellet Insert 9 10 11 12 13COMMENTS #4 Surround AssemblyP35i Pellet Insert DescriptionPART NUMBER P35i Pellet InsertDescription COMMENTSPART NUMBER P35i Pellet InsertDescription COMMENTSP35i Custom Surround Part #: 1-00-774221-SPL D. Custom Size SurroundHearth & Home Technologies Inc LIMITED LIFETIME WARRANTYWARRANTY COVERAGE WARRANTY PERIODLIMITATIONS OF LIABILITY WARRANTY CONDITIONSWARRANTY EXCLUSIONS This warranty is void ifP35i Fireplace Insert Service & Maintenance LogDate Of Service Description Of ServiceProudly Printed On 100% Recycled Paper