P35i Fireplace Insert
4.Distribution Blower
Requires no lubrication.
Keep the motor windings and squirrel cage fan free of dust. Can be wiped clean or vacuumed.
To remove distribution blower;
•Slide the insert body out of the mounting frame.
•Locate the blower in the back of the unit. You'll need to tilt the unit forward for easy access.
•Remove 8 tek screws using a 5/16" driver or wrench.
8 screws
5.Feeder Body
Wipe or vacuum to clean.
Use a vacuum to remove fines and sawdust.
To access feeder cleanout;
•Slide the insert body out of the mounting frame.
•Locate the feeder cover from the right side of the unit.
•Loosen the wing nut approximately 3/4 of the way out on the stud.
•Pull out on the bottom of the cover then lift upward to remove.
•Notice the deflector shield is sitting loose in the feeder. It can be removed by rolling it from under the pusher arm shaft. Just be sure it is reposi- tioned properly.
•When
Loosen wing nut to remove cover
Vacuum fines from this area
36 Pellets or Corn/Pellet Mixture Only | Save These Instructions |