Heat & Glo LifeStyle XLR-N-CE Mantel and Wall Projections, Mantels Combustible/Non-Combustible

D. Mantel and Wall Projections

WARNING! Risk of Fire! Comply with all minimum clear- ances to combustibles as specified. Framing or finishing material closer than the minimums listed must be construct- ed entirely of noncombustible materials (i.e., steel studs, concrete board, etc).

Mantels (Combustible/Non-Combustible)

1,3 cm Thick Wall

Sheathing 30 cm

MAX.

MEASUREMENT

36 cm FROM TOP OF MIN. FIREPLACE

OPENING

Figure 5.3 Clearances To Combustible/Non-Combustible

Mantels Or Other Combustibles/Non-Combust-

ibles Above Appliance.

Note: For non-combustible fireplace finish material (marble, stone, etc) specifications refer to Section 13.C.

Mantel Leg (Combustible/Non-Combustible)

TOP VIEW

8 cm

MINIMUM UNLIMITED

18 cm

Figure 5.4 Non-Combustible Mantel Leg or Wall Projections (Acceptable on both sides of opening)

2,5 cm

FRAMING

NAILING TAB

1,2 cm FACTORY-SUPPLIED

NON-COMBUSTIBLE BOARD

Figure 5.5 Front Side Finishing Detail

8,90 cm

NON-COMBUSTIBLE

BOARD SHIPPED

WITH APPLIANCE

2,5 cm

2,5 cm

AIR SPACE

Figure 5.6 Non-Combustible Zone

Note: AIR SPACE denoted in Figure 5.6 is defined by the nailing tabs and metal standoffs.

Note: Factory installed non-combustible board may only be replaced with HHT product code SUPERM-60material and must be fully replaced in its entirety.

20 Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. J • 5/12