Electrical Information | Heat & Glo LifeStyle XLR-N-CE, XLR-PB-CE

12 Electrical Information

A. Wiring Requirements

NOTICE: This appliance must be installed by a qualified electrician in accordance with the relevant national and local regulations.

•Wire the appliance junction cord to 230 VAC. This is required for proper operation of the appliance.

WARNING! Risk of Shock or Explosion! DO NOT wire 230 VAC to the valve or to the appliance wall switch. In- correct wiring will damage controls.

NOTICE: The mains supply to the appliance must have isolation of a minimum 3 mm contact separation in both poles.

WARNING! Risk of Injury! The gas supply shall be shut off prior to disconnecting the electrical power and remov- ing batteries (if installed) before proceeding with any maintenance to the appliance.

B. IntelliFire Plus™ Ignition System Wiring

•Wire the appliance junction cord to 230 VAC for proper operation of the appliance.

WARNING! Risk of Shock or Explosion! DO NOT wire IPI controlled appliance junction cord to a switched cir- cuit. Incorrect wiring will override IPI safety lockout.

•Refer to Figure 12.1, IntelliFire Plus™ Pilot Ignition (IPI) Wiring Diagram.

•This appliance is equipped with an IntelliFire Plus™ control valve which operates on a 6 volt system.

•Plug the 6-volt AC power supply into the appliance junction cord to supply power to the unit OR install four AA cell batteries (not included) into the battery pack before use.

•This appliance ships standard with an electrical supply cord.

NOTICE: If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufac- turer or its service agent.

C. Optional Accessories Requirements

•This appliance may be used with a wall switch, wall mounted thermostat and/or a remote control.

Wiring for optional Hearth & Home Technologies approved accessories should be done now to avoid reconstruction. Follow instructions that come with those accessories.

Optional Remote Control Receiver and Battery Pack Location

The battery tray, control module, and remote control re- ceiver can be accessed through the air space between the firebox front and the lower-front finishing cover panel. The decorative front and glass assembly must be re- moved to access these components.

The battery tray is attached with Velcro to the inside of the lower cover panel. The IPI control module and the remote control receiver are placed on the firebox bottom.

NOTE: 1. Ignition module, valve, pilot, and wall switch operate on 6 volts. 230 VAC is required at junction cord unless equipped with battery back-up.

MODULE RESET