14 Appliance Setup
A. Remove Fixed Glass Assembly
See Section 14.E.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the firebox. The standard black rock media and manual bag assembly are also shipped underneath the firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home
E. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fixed glass assembly with care. Inspect the gasket to ensure it is undamaged and inspect the glass for cracks, chips or scratches.
•DO NOT strike, slam or scratch glass.
•DO NOT operate fireplace with glass removed, cracked, broken or scratched.
•Replace as a complete assembly.
Removing Fixed Glass Assembly
1.Remove the decorative front.
2.Locate the two spring latches that are on the upper left and right of the fireplace.
3.Use both index fingers to release spring latches. See Figure 14.1.
4.Allow glass to tilt forward. Grasp glass on the upper right and left sides and lift glass “up” and “out.”
Replacing Fixed Glass Assembly
1.Locate glide tabs on lower left and right corners.
2.Grasp glass on upper right and left sides and tilt bot- tom of glass assembly toward fireplace.
3.Allow of the bottom gasketing of the glass assembly to touch the face of the fireplace.
4.Put pressure on the glass as you allow the glass assem- bly to drop into the two lower tabs. See Figure 14.1.
5.Tilt top of glass towards fireplace and engage both top spring latches.
UPPER SPRING LATCH
LOWER GLASS CLIP
Figure 14.1 Fixed Glass Assembly
F. Install the Mesh
The mesh front is included with the Tonic front. The Mar- tini tinted glass front does not include mesh.
1.Remove fixed glass assembly as instructed.
2.Place glass assembly into mesh screen such that the four mesh clips attached to the mesh assembly snap into the four corresponding slots on the fixed glass as- sembly.
50 | Heat & Glo • |