24
STOVE AND
Installing Optional Wireless
STOVE AND DIRECT-VENT BURNER SYSTEM INSTALLATION
Continued
4.Place receiver into valve bracket and align holes (see Figure 50).
5.Use
6.Connect the wires from the receiver to the valve at TH and THTP (see Figure 46, page 22).
TPTH TP TH
Figure 50 - Installing Remote Receiver
Installing
1.Remove battery cover on back of remote control unit
2.Attach terminal wires to a
3.Replace battery cover onto remote control unit.
Battery Remote
Terminal
Cover Control Unit
Wires
Battery
Housing
Figure 51 - Installing Battery in Hand-Held Remote Control Unit (GHRC Series)
Terminal | Remote | ||
Wires | |||
Battery | |||
| Control | ||
|
| ||
|
| Unit | |
|
| Battery | |
Battery Housing |
| Cover |
Figure 52 - Installing Battery in Hand-Held Remote Control Unit (GHRCTA Series)
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install logs, lava rock, and ember material. To remove glass door, you must first remove the front panel on stove body.
CAUTION: Do not operate this burner system with a broken glass door panel or without the glass door panel securely in place. For replacement part infor- mation see Replacement Parts, page 33.
1.Remove 2 bolts from bottom of stove (if still installed) and one from the top of stove to remove front panel (see Figure 53).
2.Remove the screws from the 2 tabs at the top of the glass door while holding door securely keeping it from falling forward (see Figure 54).
3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 54).
4.To replace glass door, follow the above instructions in reverse.
Bolt
Stove Front
Panel
Bolt 
Figure 53 - Removing Front Panel from Stove
Screw
Glass
Door
Figure 54 - Removing Glass Door from Burner System
For
.
.com
