Removing Pallet Wood From The Bottom of The Stove

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Stove Body Assembly (Cont.)

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Continued

6.Remove all contents from inside stove cavity. Contents include:

(1)- Stove bottom (Discard - Not used with this application)

(4)- Legs with leg leveler bolts

(1)- Bottom door

(3)- Top grates

(1)- Hardware kit bag with fasteners

7.Carefully lay stove body on back to attach bottom components to stove body (see Figure 7). Rest stove on drop cloth or blanket to avoid scratching stove edges.

8.Remove remaining pallet wood attached to bottom of stove body (see Figure 8). Use an adjustable wrench to remove bolts.

9.Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figures 9 and 10). Use an adjustable wrench or a 12mm and 6mm socket.

10.Attach stove door by inserting step bolt through door hinge pivot hole and into threaded hole in stove body (Figure 11 on page 7 and Figure 9). Use an adjustable wrench or a 12mm socket to fasten step bolt. Tighten step bolt until snug. Make sure door moves freely.

11.Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded hole on stove body (see Figure 9). Use an adjust- able wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 12, page 7). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.

12.Check general catch bolt alignment with door claw. Make final adjustment and door leveling after stove is in normal standing position.

13.Carefully lift stove back up on its four attached legs.

14.Remove 2 bolts from bottom of stove and discard. Remove bolt from the top of the stove to remove the front panel assem- bly (see Figure 13, page 7).