STOVE AND
Installing Logs, Lava Rock and Glowing Embers
25
STOVE AND DIRECT-VENT BURNER SYSTEM INSTALLATION
Continued
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this burner system may result in property damage or personal injury.
It is very important to install these logs exactly as instructed in Figures 55 through 58. Do not modify logs. Only use logs supplied with freestanding burner system. Do not use if any log(s) are broken (see Replacement Parts, page 33).
1.Remove glass door. See Removing/Replacing Glass Door, page 24.
2.Place log #1 (back log) on top of grate. Make sure the notches in the bottom of the log fit over the grate (see Figure 55).
2.Rest log #2 (large front log) on the pins on the front part of the grate (see Figure 56).
3.Place log #3 (crossover log) onto the rear and front logs. Make sure it is seated properly into the notch on the front log and over the raised triangular portion of the rear log as shown in Figure 57.
4.Place log #4 (small log) onto the front left part of the grate making sure the notches fits over the prong of the grate. See Figure 58.
5.Lava rock may be placed along sides and front inside burner system bottom. This may not be visible when you have re- placed the front of the stove. It is not necessary to use all of the lava rock provided.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner could cause performance problems.
6.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the ex- posed section of the front burner and along the space between the burner and grate prongs (see Figure 59). This will create the glowing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember ma- terial in one area. It is not necessary to use all of the ember material provided.
7.Replace the glass door and stove front. See Removing/Re- placing Glass Door, page 24.
WARNING: The glass door must be securely in place before running this burner system. Do not run this burner system if glass is missing or broken.
3 | 4 |
|
1 
2
Figure 57 - Installing Log No. 3 Figure 58 - Installing Log No. 4
Figure 55 - Installing Log | Figure 56 - Installing Log No. 2 |
No. 1 | Figure 59 - Placing Ember Material on Burner |
|
For more
visit www.
.com
