Regency Complete Installation Guide for Your FP90 Indoor Fireplace

INSTALLATION

WIRING THE FP90

Field wire main power supply to fi replace blower system. (All electrical connections should only be performed by a licensed/certifi ed electrician).

CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.

Plan View Jakel AX-2495 Blower

Angle View

INSTALLATION

INSTALLING THE

BLOWER SYSTEMS

The FP90 Fireplace has been designed to meet a wide range of heating requirements. The radiant heat (through the large glass area) combined with the naturally convected heat, allows the FP90 Fireplace to adequately heat an average sized room. Ablower is recommended to assist in heating a larger area or one with wall separations. Through the use of two separate blower systems, Regency has developed the basic blower wiring options listed in the diagrams shown.

Fan Transfer Plate

Front View

		Right View
Fan 910-175 AX-3088	910-903
	910-516
	Ground	Switch
			Power Chord 910-619
811-910	Neutral - from Fan	Variableto
			Ground
	919-885
		Hot-
Thermodisc 910-142 P60T12	Variable Switch 910-330

Internal Blower with Thermo-Disc

The thermodisc provides the user with more convenient control. The fan operates automati- cally - turn the knob to adjust to desired speed. The fan will turn on as the stove comes up to operating temperature. After the fire cools to below a useful heat output range the fan will shut off automatically.

Place sticker on outside of bottom louver.

GRAVITY AIR FEED KIT OPTION

6" (152mm) Min.

The Gravity Air Feed Kit is designed to extend the heat output vent above the FP90 to the front or the side. The upper louver opening is blocked off and fl ex vent is connected to the vent holes in the

Ceiling

Flue

To Rouch Opening

top of the unit and run to discharge vent grilles. Both 8" (203mm) diameter insulated Flex vents must be used along with one 30 sq. inch (194cm2) chase vent grill to bring additional air into the chase (for U.S. installations only).

Insulation

Strips

Qty Description

4Connector Collars

4Adjustable Clamps

25’ lengths of fl exible vent pipe (8” dia.)

2Insulated Sleeves

1	Block Off Plate
2	Discharge Vent Mounting Frames	Discharge Vent
7	1/4-20 x 1/2” Truss Head Screws	Grill
	(used for EX90/R90 only)

Connector

Collar

Outside Air Intake

	Center-line
Flex Vent	of Vent

	Vent Cover 'A"
	Vent Cover 'B'
Clamp	(Inside)
Connector
Collar	Base of Stove

216 x 8 Discharge Vent Grilles

4#8 Drywall Anchors

4	Insulation Strips	Chase Vent
1	Chase Vent Frame	Grill
	(not required for FP90)

18 x 8 Chase Vent Grille

Block-off Plate

(replace top louver)

Alternate Position for

Chase Vent Grill

(not required for FP90)	30 sq.in. (194 sq.cm)
	opening

16 FPI FP90 Wood Fireplace