Please Retain this Manual for Future Reference

INSTALLATION

READ BEFORE YOU INSTALL

THE REGENCY HIGH

EFFICIENCY EPA CERTIFIED

FIREPLACE

This installation manual will enable you to make a safe, efﬁ cient and dependable installation of your ﬁreplace and chimney system. Please read and understand these instructions before beginning your installation.

Do not alter or modify the ﬁ replace or its components under any circumstances. Any modiﬁcation or alteration of the ﬁreplace system, including but not limited to the ﬁreplace, chimney components and accessories, may void the warranty, listing and approvals of this system and could result in an unsafe and potentially dangerous installation.

PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.

IMPORTANT: Please read and follow these rules for safety.

1)Before starting your ﬁreplace installation, read these installation instructions carefully to be sure you understand them in their entirety. Failure to follow them could cause a ﬁ replace malfunction resulting in serious injury and/or property damage.

2)Always check with your local building department, fire department and local authorities prior to installation to determine the need to obtain a permit.

3)This model ﬁ replace must be installed with one of the chimney systems listed in the Chimney Section in this manual. These systems are intended for use as a residential type appliance. The chimney must always vent to the outside of the building.

4)WARNING: THIS FIREPLACE HAS NOT BEEN TESTED WITH AN UNVENTED GAS LOG SET. TO REDUCE RISK OF FIRE OR INJURY, DO NOT INSTALL AN UNVENTED GAS LOG SET INTO THE FIREPLACE.

5)To ensure a safe ﬁ replace system and to prevent the build-up of soot and creosote, inspect and clean the ﬁ replace and chimney prior to use and periodically during the heating season.

6)Use solid fuel only. DO NOTuse artiﬁcial logs containing petroleum products, chemical chimney cleaners, gas logs, gas lighters, salt contaminated wood or ﬂ ame colorants in your ﬁreplace. When using compressed sawdust logs use only at 1/3 capacity since these get very hot and expand.

7)DO NOT use charcoal or coal under any circumstances.

8)NEVER use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter ﬂ uid, or any liquid to start or “freshen up” a ﬁre in this ﬁ replace. Keep any ﬂ ammable liquid a safe distance from the ﬁ replace.

9)Ashes should be placed in a metal container with a tight-ﬁ tting lid. The closed container of ashes should be placed on a non-combustible ﬂ oor or on the ground, well away from all combustible materials, pending ﬁ nal disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled.

10)WARNING: Only operate ﬁreplace with doorsfullyopenwhenoptionalﬁrescreen is used.

11)NEVER leave children unattended when there is a ﬁ re burning in the ﬁ replace.

12)Allow the ﬁ replace to cool before servicing. Always shut-off any electricity to the ﬁreplace while working on it. This will prevent any possible electrical shock.

13)Regency is not responsible for any smoking or related problems that may result from the lack of adequate combustion air. It is the responsibility of the installer to ensure that adequate combustion air has been provided for the ﬁreplace.

Emissions from burning wood or gas could contain chemicals known to the StateofCaliforniato causecancer,birth defects or other reproductive harm.

14)FPI Fireplace Products International Ltd. does not warranty “smoke-free” operation nor are we responsible for inadequate systemdraftcausedbymechanicalsystems, general construction conditions, inadequate chimney heights, adverse wind conditions and/or unusual environmental factors or conditions beyond our control.

15)IMPORTANT: Check with your local building department as to the requirements of sealing any penetrations to the exterior. This will ensure that the integrity of the building is intact.

16)DO NOT use a ﬁ replace insert or any other product not speciﬁ ed by Regency for use with this ﬁ replace.

17)NEVER, under any circumstances, install a ﬁ replace, chimney component or any accessories, supplied by Regency, that have visible or suspected physical damage as a result of handling or transportation. These items should be inspected by a Regency dealer or qualiﬁ ed factory representative to ensure safe condition. When in doubt, consult your Regency dealer.

18)It is recommended that power is supplied to the terminal block of the unit to allow for the installation of blower components now or at a future date.

6	FPI FP90 Wood Fireplace