INSTALLATION
MASONRY LINER /
BRICKS
GLASS | SECONDARY AIR TUBE |
INSTALLATION | INSTALLATION |
INSTALLATION
Insulated refractory panels are included to extend the life of the fireplace and help radiate heat more evenly. Make sure Insulating Paper is in place along the bottom, side and rear before bricks are put into place.
Using the diagram to fi nd the correct location of the panels install in the following sequence: rear, sides, bottom, top. Care should be taken nottodamagethepanelsduringinstallation.THE
ANDIRONS SHOULD NOT BE REMOVED.
Side
Panel
Top
Panel
Insulation 
Top 
Brick
Bottom
Vermiculite
Remove the wire retainer from the doors, and place the glass in the doors, making sure that the glass gasketing will properly seal your unit. The retainer should be resting on the gasketing not on the glass. Tighten securely, but do not wrench down on the glass as this may cause breakage. Do not substitute materials. If your glass door breaks, do not use your unit until it has been replaced.
1)Slide air tube into the hole on the left hand side of the firebox as far as it will go. The notch in the air tube should be facing the right hand side of the fi rebox.
2)Slide the air tube back towards the right side until it locks into place. To lock into position, use a pair of vise grips and tap them with a mallet until the tube locks into place. The air holes should be pointing down toward the primary air opening just inside the bottom of the door opening. The air tube will be diffi cult to snap into place because it has to be a snug fit in order to prevent it from falling out when a fi re is burning.
20 | FPI FP90 Wood Fireplace |