Mitsubishi G-50A Starting and Ending the Application, Starting the Maintenance Tool, Normal mode

1.4 Starting and Ending the Application

1.4.1Starting the Maintenance Tool

(1)Connect the computer and G-50A(MN Converter) and air conditioner.

(2)Click on “Start”, and then click on ”Programs”.

(3)Click on “Maintenance Tool for Windows2000 & XP” in the “Maintenance Tool” folder.

(4)The Title Screen will soon appear.

In addition, the message of [This unit can be changed into °F and pounds/inch2. Do you change them?] is

displayed, and the temperature is set into °F if is

clicked on, while into °C if is clicked on.

*After upgrade, if a maintenance tool is started for the first time, conversion processing of a database may be performed. In this case, "Now, Converting database! " and a progress state are displayed.

*The capacity to store the data obtained by the maintenance tool counts for 2G-bite maximum.

When the remaining storage capacity is insufficient at starting, Warning Screen will appear.

In this case, move to OFF- Line Screen to delete unnecessary data.

(5)Thereafter, the selection screen of Monitor mode is displayed. Selecting the mode to be adapted.

Normal mode

a) ON LINE MODE

- MN CONVERTER

When on-line monitoring is adapted to air conditioning system by connecting MN Converter [Refer to 1.4.2.1.] Further select Remote connection to conduct remote connection. [Refer to 1.4.2.2.]

- G50(LAN)

When on-line monitoring is adapted to air conditioning system via G-50 by connecting the maintenance tool to LAN. [Refer to 1.4.3.1.] For remote connection, select either “Dialup connection mode” or “E-mail connection mode”. [Refer to 1.4.3.2., 1.4.3.3.]

b)OFF LINE MODE

-Offline analysis

When offline analysis is adapted to the data collected under ON-LINE MODE [Refer to 1.4.4.]

Wide area access mode

The detail is described in the item 1.4.5.

9