6 How to change setting of Firewall
How to Change Setting of Firewall for Windows XP
1.Introduction
When connecting Maintenance Tool through
(* In E-Mail mode and MN converter connection, it is not related)
Therefore, the setting of Firewall should partially be changed following the procedure indicated in Chapter 3 How to change the setting of Firewall.
2.Applicable case
(1)Should the following symptoms occur at the Address Searching of OC (051~100), it may be possible that the communication from
•Requiring a lot of time for searching
•Not displaying the connecting relation (as shown in the right figure)
In such case, terminate Maintenance Tool once, and change the setting of Firewall.
3.How to change the setting of Firewall
The method to change the setting differs depending on the Service Pack loaded as explained below.
•
I)In the case of
II)In the case of
•
3-1 [For Windows XP Service Pack 1]
I)In the case of
(1)Select [Control Panel] from Start menu.
(2)Click [Switch to Classic View] to switch the [Control Panel] screen to Classic View.
(3)
[Classic View]
(4)The [Network Connection] screen will be displayed.
(5)
(6)Select [Properties] from the sub menu, and then click it.
59