Mitsubishi MN Converter, G-50A manual Malfunction Log Trouble

large!! Please, delete old monitor data!!" is	insufficient.	unnecessary data.
displayed during collecting data.
Data becomes a red display and the "-"	Since data cannot receive normally.	- Reduce the number of a monitor.
display.	- There is too much number of a monitor.	- Cope with noise generating origin.
	- Data transforms itself by a noise.	* Also when returning from a graph
		screen to an operation screen, it may
		become a red display and the "-"
		display, but it is normal.

Malfunction Log Trouble

Trouble	Cause	Repair
Cannot clear malfunction log	The unit is not compatible with	The malfunction log cannot be cleared.
	malfunction log clear.
There is an error code, but the contents of	This is a newly added error code and is	Refer to the service handbook for that
the error are not displayed	not compatible with the maintenance	unit.
	tools.

Operation Monitor Mail Communication Mode Trouble

Trouble	Cause	Repair
Operation monitor mail cannot receive	A mail address and SMTP server	Please set up the right information again
normally.	information were made a mistake in and	after performing "Stop mail
		communication" of 3.4 (2).
	set up by mail communication setup.
	The mail address a contract of is not	Please set the regular mail address a
	made with a provider was set as [FROM:	contract of is made with the provider to
	Mail Address].	[FROM: Mail Address].
	(When using dialup)
	The mail address of recipient (To:) is not	The mail address of recipient (To:)
	an address only for maintenance tools.	acquires and sets up the address only for
		maintenance tools.
	(The mail address used usually is set up.
	In this case, once other mail software
	receives mail, operation data mail will be
	deleted from a mail server.)
The analysis screen of the operation	The system configuration information	Please delete the corresponding data.
monitor data (which carried out mail	acquired from G-50 immediately after a	Text conversion can be carried out and
acquisition by OFFLINE) is not displayed.	mail communication setup was not	data can be outputted.
	acquired normally.
	Mail communication mode was set up	When mail communication mode is set up
	from the maintenance tool of a remote	from the maintenance tool of a remote
	place, and the mail address of recipient	place, mail acquisition of operation data
	(To:) was set as another addressing to a	can be performed only with the
	maintenance tool of a remote place.	maintenance tool which set up.
	(System configuration information mail is	Please make a set the mail address of a
	transmitted from G-50 immediately after a	maintenance tool which set mail
	mail communication setup.	communication mode to the mail address
		of recipient (To:).
	However, the maintenance tool by the
	side of a setup is using dial-up service,
	and mail transmission cannot be
	performed.
	Consequently, since the maintenance tool
	with which mail is transmitted cannot
	acquire system configuration information
	mail, even if it receives after that
	operation monitor data mail, it does not
	indicate by normal.

66