1.3 Installation
There are two Maintenance Tool setup methods: Method 1) New setup.(See Section 1.3.1)
Method 2) Upgrading with existing setup.(See Section 1.3.2)
Caution
Please refer to also 1.3.4 RE: Change of computer name on PC.
1.3.1 Setting Up the Maintenance Tools (New setup)
To set up Maintenance Tools, follow the 3 steps below.
Step 1) | Setting up of MSDE | : After finishing Step 1, PC restarts automatically. |
Step 2) | Setting up of database | (Restarting PC is essential before going to Step 2.) |
Step 3) | Setting up of Maintenance Tools |
|
Request
•For setting up, be sure to practice 3 steps in order. Otherwise, Maintenance Tools will not operate normally.
•Before setting up, be sure to log in with the
Step 1) Setting up the MSDE
Notice
•Before Setting up the MSDE, restart your computer and Ending software for application program and
Execute “SETUP.exe” located in SetUp ¥1_MSDE4VS in the folder of
Double clicking on “SETUP.exe” with the explorer displays the MSDE setup screen as shown right.
PC is reset automatically after completing installation of MSDE. After closing other application software, click [OK] and start installation.
* To stop setting up, click on [Cancel] button.
The setting up processing requires for about
If processing progresses to 100%, the screen in the right will be displayed. Clicking on [OK] resets PC automatically. Please carry out STEP2 after PC's starting.
Notice
After setting up MSDE, PC is designed to automatically reset. However, if this setting up is executed without finishing other application software, PC may not be reset automatically. In this case, reset PC manually. After restarting, go to Step 2. Without restarting PC, Maintenance Tool can not be set up unless replacing OS itself.
Step 2) Setting up the database
Execute “Setup.bat” located in the folder of SetUp ¥2_DB_SETUP” of
Double clicking on “Setup.bat” with the explorer displays the command prompt screen.
The setting up processing ends within about 10 seconds
-3 minutes.
After ending of the setting up, “Press any key to continue …”
is displayed. Pressing any key closes the command prompt screen.
5