1. Safety instructions
These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard by labeling "Caution", "Warning", and "Danger". To ensure safety, be sure to observe ISO4414, JIS B8370and other safety precautions.
! | CAUTION | Operator error could result in injury or equipment damage. |
! | WARNING | Operator error could result in serious injury or loss of life. |
! | DANGER | In extreme conditions, there is a possibility of serious injury or loss of life. |
※1) ISO 4414 : Pneumatic fluid power
※2) JIS B 8370 : Rule for Pneumatic System
!WARNING
1.The compatibility of equipment is the responsibility of the person who designs the system or decides its specifications.
Since the products specified here are used in various operating conditions, their compatibility with the specific system must be based on specifications or after analysis and/or tests to meet your specific requirements. Those who decide the compatibility of equipment shall take the responsibility to guarantee the initial system performance and safety. Construct system as reviewing all specifications in the latest catalog or documents as well as considering the possibility of equipment in every occasion.
2. Only trained personnel should operate machinery and equipment.
This product generates high voltage, so it can be dangerous if an operator is unfamiliar with it. Assembly, handling or repair of systems should be performed by trained and experienced operators.
3.Do not service machinery/equipment or attempt to eliminate components until safety is confirmed.
1)Inspection and maintenance of the machinery and equipment should be performed after confirmation of the safety such as earthing, prevention of electric shock and each type of injury.
2)When equipment is to be eliminated, confirm the safety process as mentioned above. Cut air pressure supply and electric power supply that are the energy source for the equipment, and exhaust all residual compressed air in the system.
3)Before machinery/equipment is
4.Do not use product under the following conditions or environments. If it is not avoidable, take appropriate measures and contact SMC.
1)Conditions and environments beyond specifications or if product is used outdoors.
2)Installation on equipment in conjunction with atomic energy, railway, air navigation, vehicles, medical equipment, food and beverage, recreation equipment , emergency stop circuits, pressing clutch, break circuit and safety equipment.
3)An application which has the possibility of having negative effects on people, property, or animals requiring special safety analysis.
2