North Star 864 HH installation manual Wiring Diagram -864TRV

62 Optional Equipment (for qualified installers only)

Wiring Instructions

Warning: All wiring should be done by a qualified electrician and shall be in compliance with local codes and with the current National Electric Code ANSI/NFPA 70.

Warning: Make sure the fireplace electrical circuit is disabled prior to working on electrical hookup.

Wiring Diagram - 864 HH*, 44 DV XXL, and 36 DV

		Fireplace					Blower
							Snap Disk
Supply	Hot			Hot		Molex		Molex	Hot
	Common		Common						Common
	(black)		(black)						(black)
					Connector			Connector
Power	(white)		(white)						(white)
	Ground		Ground						Ground
	(green)		(green)						(green)

Hot

(black)

Common

(white)

Ground (green)

Hot

(black)

Heat Duct Rheostat

Rheostat

Junction

Box

Hot

(black)

Common

(white)

Ground (green)

Heat Duct

Blower

Hot

(black)

Common

(white)

Ground (green)

Blower

Junction

Box	Grounded
	to Blower

Fireplace Fireplace

Blower Rheostat

Common

(white)

Ground (green)

Optional Second Heat

Duct (same rheostat and

blower wiring as above)

Wiring Diagram -864TRV

*864 HH SN 3407-001010 or greater. 864 HH SN 3407-001009 or less uses wiring similar to the 864TRV.

Power Supply

Hot

(black)

Common

(white)

Ground (green)

Rheostat

Junction Box

Hot

(black)

Common

(white)

Ground (green)

Blower

Assembly

1Follow the directions below to wire the blower box.

a

Remove the cover from the blower box.

Phillips

Screwdriver

b

Standard

Screwdriver

Insert sheathed cable through the cable clamp. After the wires have been connected tighten the clamp to secure the cable.

c	Attach the hot (black) and common (white) wires to the
	leads coming from the wires (use wire nuts).

Secure the ground wire to the ground stud inside the d blower box by tightening the included nut over the

ground wire. Re-attach the cover removed in step "a".

Ground Wire

Travis Industries 4070201 100-01182_002