56 | Optional Equipment (for qualified installers only) |
Remote Control Receiver Installation (2 Options)
The instructions below detail installation of the optional remote control receiver. For operating instructions, refer to the instructions included with the remote.
OPTION # 1 - Remote Thermostat (99300653)
Attach the power cord to the
electrical receptacle on the inside
of the fireplace.
WARNING: Make sure the power cord does not contact the blower (if applicable) or the bottom of firebox (or other hot surface).
Use
Place the receiver in a location to the left of the gas control valve (near the front of the fireplae).
Attach the two reciever wires to the top and bottom posts on the gas control valve (orientation does not matter).
OPTION # 2 - Remote Thermostat (99300676)
Remove and discard this molex connector attached to the blower wiring harness.
Connect the receiver to the molex connector on the wiring harness.
Place the receiver in a location to the left of the gas control valve (near the front of the fireplae).
Travis Industries | 4070201 |