Hearth and Home Technologies SL-550TRSI-AUE manual USE DVP-SERIES Components

Page 12

NOTE: A 146mm section of vertical pipe must be attached to the heater before a 900 elbow.

USE SL D-SERIES

COMPONENTS

ONLY.

H

V

	FLUEING WITH ONE (1) 90° ELBOW
	V		H
	FT. (M)		FT. (M)
	1' MIN.(0.30M)		2' MAX.(0.61M)
	2' MIN.(0.61M)		4' MAX.(1.22M)
	3' MIN.(0.91M)		8' MAX.(2.44M)
	4' MIN.(1.22M)		10' MAX.(3.05M)
Figure 11.	V + H = 30' (9.14M)
Figure 11.
FLUEING WITH ONE (1) 90o ELBOW
V (FT.)		H (FT.)
1' MIN. (0.30M)		3' MAX. (0.91M)
2' MIN. (0.61M)		6' MAX. (1.83M)
3' MIN. (0.91M)		9' MAX. (2.74M)
4' MIN. (1.22M)		12' MAX. (3.66M)
V+H =36' MAX. (10.97M)		H= 12' MAX. (3.66M)
			V
USE DVP-SERIES
COMPONENTS
	ONLY.
Figure 12.
12		Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06

Image 12

Contents Model SL-550TRSI-AUE Kensington Boulevard, Lakeville, MN 55044 USAHeat & Glo Quality Systems registered by SGS ICS Table of Contents Diagram of SL-550TRSI-AUE Installation Instructions Top FlueRear Flue Framing Dimensions IntroductionSpace heaters Flue System Approvals Model Flue Termination ApprovalsIdentifying Flue Components DVP90ST Heat & Glo SL-550TRSI-AUE 2079-902 Rev. B 7/06 Vertical Flueing Maximum 10.97MUSE SL D-SERIES USE DVP-SERIES Components onlyUSE SL D-SERIES Components Only Flueing with ONE 1 90 Elbow USE DVP-SERIES ComponentsFlueing with TWO 2 90 Elbows + H FT. MFT. V M FT. HM Flueing with TWO 2 90 Elbows Flueing with Three 3 90 Elbows + H1 FT. MFlueing with Three 3 90 Elbows Installing Flue Components Nent and the Outer Heater Wrap Assembling Flue ComponentsInstall Support Brackets Continue Adding Flue ComponentsInstalling Support Brackets Hole and New Framing MembersFlue Termination Connecting the GAS Supply Gas Supply LineIgnition System Wiring Shock RiskBlower FAN Finishing CeilingInstaller Testing Installing the TrimPilot Assembly 3 4 5 6 7 Heat & Glo SL-550TRSI-AUE 2079-902 Rev. B 7/06 Heat & Glo SL-550TRSI-AUE 2079-902 Rev. B 7/06 Trol Wiring System of this Unit Operating InstructionsOperating This Appliance MAY Exhibit a Slight Carbon DepositionSafety & Lighting Information Do not Connect 220/240 VAC to the Control ValveServicing and Maintenance Glass Door When IT is HOTFAN Operation Removal of Components for Service Parts ReplacementAdjustments and Replacement Parts Removal of Covers for ServicingMaintenance Tasks Doors Inspect Maintenance TasksTroubleshooting Electronic Ignition SystemPan beneath the burne Log set assembly SL-550TRSI-AUESL-550TRSI-AUE Service Parts List Heat & Glo SL-550TRSI-AUE 2079-902 Rev. B 7/06 Melbourne