2.1SAFETY & LIGHTING INFORMATION
Follow SAFETY INFORMATION and LIGHTING IN- STRUCTIONS to light the appliance.
By design, the flame pattern will not be identical from unit to unit. Additionally, flame pattern may vary depend- ing on installation type and weather conditions.
After the unit has warmed up (i.e. approximately 15 min- utes) flame height should be slightly (about 2" (51mm) below the top of the mesh trim assembly. If the flame height is higher than this, adjustments must be made to prevent overheating the gasket and glass. Please con-
tact your dealer or a qualified service person to replace the injector or adjust the valve.
NOTE: THE TIPS OF THE FLAMES SHOULD NEVER HIT THE TOP OF THE FIREBOX.
These gas models have remote control valve which al- low you to increase or decrease the height of the main burner flames. Push the 
button to increase the flame height and the 
button to decrease the flame height.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
LIGHTING
INSTRUCTIONS
1. This gas fireplace is equipped with an |
ignition device which automatically |
A. This appliance is equipped with an electronic ignition device which automatically lights the burner. Do not try to light the burner by hand.
B. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
WARNING:
DO NOT CONNECT 220/240
VAC TO THE CONTROL VALVE.
Improper installation, adjustment, alteration, service or maintenance can cause injury or property dam- age. Refer to the owner's informa- tion manual provided with this ap- pliance.
This appliance needs fresh air for safe operation and must be in- stalled so there are provisions for adequate combustion and ventila- tion air.
If not installed, operated, and main- tained in accordance with the manufacturer's instructions, this product could expose you to sub- stances in fuel or fuel combustion. Keep burner and control compart- ment clean. See installation and operating instructions accompany- ing appliance.
•Do not touch any electric switch; do not use any phone in your build- ing.
•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas sup- plier, call the fire department.
C. Do not use this appliance if any part has been under water. Imme- diately call a qualified service tech- nician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
CAUTION:
Hot while in operation. Do not touch. Keep children, clothing, fur- niture, gasoline and other liquids having flammable vapors away.
Do not operate the appliance with panel(s) removed, cracked or bro- ken. Replacement of the panel(s) should be done by a licensed or qualified service person.
NOT FOR USE
WITH SOLID FUEL
For use with natural, propane and butane gases.
lights the burner. Do not try to light the |
burner by hand. |
GAS
VALVE
2.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low "B" in the Safety Information located on the left side of this label. If you don't smell gas, go to next step.
3.To light the burner, simultaneously press the star and up arrow but- tons on the remote control until a short acoustic signal confirms the start se- quence has begun.
4.If the gas fireplace will not operate, check the batteries then follow the instructions “To Turn Off Gas to Ap- pliance” and call your service techni- cian or gas supplier.
TO TURN OFF
GAS TOAPPLIANCE
1.Push the "OFF" button on remote.
2.Remove power from receiver.
Heat & Glo • | 31 |