Hearth and Home Technologies SL-550TRSI-AUE Flue System Approvals, Identifying Flue Components

TABLE 1

MODEL	FLUE TERMINATION APPROVALS
	DVP-TRAP2 & SLK-01TRD HORIZONTAL TERMINATION CAP
SL-550TRSI-AUE
	DVP-TVHW & SLK-991DA VERTICAL TERMINATION CAP

1.2 FLUE SYSTEM APPROVALS

These models have flue starting collars on both the top and the back of the unit. Depending upon the installa- tion, decide which ONE set of starting collars will be used to attach the flue system. The starting collar sealing cap must remain on the starting collar NOT used.

These models use SL-D-series direct flue components when using the TOP flue collars and DVP-series direct flue components when using the REAR flue collars.

WARNING: YOU MUST NOT MIX DVP-SERIES AND SL D-SERIES COMPONENTS IN ANY FLUE SYSTEM CONFIGURATION.

Approved flue system components are labeled for identification. NO OTHER FLUEING SYSTEMS OR COMPONENTS MAY BE USED. Detailed installation instructions are included with each flue termination kit and should be used in conjunction with this manual. Figure 5 below shows flue system components and terminations.

Identifying Flue Components

The flue systems installed on this gas fireplace may include one, two, or three 90° elbow assemblies. The relationships of vertical rise to horizontal run in flue

configurations using 90° elbows MUST BE strictly adhered to. The rise to run relationships are shown in the flueing drawings and tables on the next few pages.

WARNING: THIS GAS APPLIANCE AND FLUE AS- SEMBLY MUST FLUE DIRECTLY TO THE OUTSIDE AND MUST NEVER BE ATTACHED TO A CHIMNEY SERVING A SEPARATE SOLID FUEL BURNING AP- PLIANCE. EACH GAS APPLIANCE MUST USE A SEPARATE FLUE SYSTEM-COMMON FLUE SYS- TEMS ARE PROHIBITED.

CAUTION: UNDER NO CONDITION SHOULD COMBUSTIBLE MATERIAL BE CLOSER THAN 3 INCHES (2 1/2 INCHES (64MM) AT WALL FIRE-

STOPS) FROM THE TOP OF THE PIPE OR 1-INCH TO THE SIDESAND THE BOTTOM FOR HORIZONTAL SECTIONS OF THIS FLUE SYSTEM. VERTICAL SECTIONS OF THIS SYSTEM REQUIRE A MINI- MUM OF 1-INCH (25MM) CLEARANCE TO COM-

BUSTIBLE MATERIALS ALL AROUND THE PIPE. For alternative installations, other than depicted, con- tact your dealer for further information.

Refer to Figure 4 for required clearances to flue terminals.

				Flue system components
			STORM
	VERTICAL		COLLAR
	TERMINATION
	HORZONTAL			ROOF FLASHING
	TERMINATION
				HORIZONTAL PIPE
				SUPPORT
				PIPE LENGTH
	WALL
	FIRESTOP
		90 DEGREE
		ELBOW	CEILING	WALL BRACKET
	Flue system termination kits		FIRESTOP
SL D-SERIES		DVP-SERIES
SLK-01TRD	SLK-991DA	DVP-TVHW DVP-TRAP2
Figure 5. Flue Components and Terminations
8	Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06