Hearth and Home Technologies SL-550TRSI-AUE manual Blower FAN

Page 24

BROWN

BLUE

NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE MUST BE RE- PLACED, IT MUST BE REPLACED WITH TYPE 105•C RATED WIRE.

BLACK

BLACK

BROWN

BLUE

GREEN/YELLOW

STRIPE

TEMPERATURE SENSOR SWITCH

BLOWER

VARIABLE

SPEED

CONTROL

BLACK

BLACK

240VAC JUNCTION BOX

BROWN

BLUE

GREEN/YELLOWSTRIPE

Figure 31.

BLUE

BROWN

GREEN/YELLOW

1.5 BLOWER FAN

These heaters have a factory installed Fan, Elec- trical Junction Box, Variable Speed Rheostat Control Switch and Temperature Sensor Switch for the fan. These components are located be- hind the lower door.

Use of the fan requires that the Junction Box (factory installed) be connected to 240 VAC service before permanently enclosing the heater. The access hole for connecting the service wires is found on the right exterior side of the unit. See Figure 32 for wire connection detail.

BLACK	BROWN
(HOT) BROWN	BLACK
BROWN
(NEUTRAL) BLUE	BLUE
BLUE
Figure 32.

24	Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06

Image 24

Contents Model SL-550TRSI-AUE Kensington Boulevard, Lakeville, MN 55044 USAHeat & Glo Quality Systems registered by SGS ICS Table of Contents Diagram of SL-550TRSI-AUE Installation Instructions Top FlueRear Flue Framing Dimensions IntroductionSpace heaters Flue System Approvals Model Flue Termination ApprovalsIdentifying Flue Components DVP90ST Heat & Glo SL-550TRSI-AUE 2079-902 Rev. B 7/06 Vertical Flueing Maximum 10.97MUSE SL D-SERIES USE DVP-SERIES Components onlyUSE SL D-SERIES Components Only Flueing with ONE 1 90 Elbow USE DVP-SERIES ComponentsFlueing with TWO 2 90 Elbows + H FT. MFT. V M FT. HM Flueing with TWO 2 90 Elbows Flueing with Three 3 90 Elbows + H1 FT. MFlueing with Three 3 90 Elbows Installing Flue Components Nent and the Outer Heater Wrap Assembling Flue ComponentsInstall Support Brackets Continue Adding Flue ComponentsInstalling Support Brackets Hole and New Framing MembersFlue Termination Connecting the GAS Supply Gas Supply LineIgnition System Wiring Shock RiskBlower FAN Finishing CeilingInstaller Testing Installing the TrimPilot Assembly 3 4 5 6 7 Heat & Glo SL-550TRSI-AUE 2079-902 Rev. B 7/06 Heat & Glo SL-550TRSI-AUE 2079-902 Rev. B 7/06 Trol Wiring System of this Unit Operating InstructionsOperating This Appliance MAY Exhibit a Slight Carbon DepositionSafety & Lighting Information Do not Connect 220/240 VAC to the Control ValveServicing and Maintenance Glass Door When IT is HOTFAN Operation Removal of Components for Service Parts ReplacementAdjustments and Replacement Parts Removal of Covers for ServicingMaintenance Tasks Doors Inspect Maintenance TasksTroubleshooting Electronic Ignition SystemPan beneath the burne Log set assembly SL-550TRSI-AUESL-550TRSI-AUE Service Parts List Heat & Glo SL-550TRSI-AUE 2079-902 Rev. B 7/06 Melbourne