Hearth and Home Technologies SL-550TRSI-AUE manual Flue Termination

If the area above the ceiling is NOT an attic, position and secure the ceiling firestop on the ceiling side of the previously cut and framed hole.

	JOIST
CEILING
NAILS (4 REQUIRED)	CEILING FIRESTOP
Figure 26. Ceiling Firestop (Ceiling Side)

If the area above the ceiling IS an attic, position and secure the firestop on top of the previously framed hole.

NAILS (4 REQUIRED)

RAFTER

CEILING

CEILING FIRESTOP

Figure 27. Attic Firestop

C. Flue Termination

For Horizontal Terminations using the DVP-TRAP To attach and secure the termination to the last section of horizontal flue:

•The rear flue heat shield MUST be placed one inch above the top of the flue between the wall shield and the base of the termination cap.

•One section of the heat shield is attached to the wall shield. The other is attached to the termination cap in the same manner (see Figure 28).

•The heat shield sections will overlap to match the wall thickness (depth).

•If the wall thickness does not allow the required 1-1/ 2 inch heat shield overlap, an extended heat shield must be used. The extended heat shield will need to be cut to the thickness of the wall and be at- tached to the wall shield.

•The small leg in the shield rests on top of the flue to properly space it from the pipe section (see Figure 28).

Interior	Rear Vent
Wall Shield	Heat Shield
	38mm min.
	overlap
Outer Flue
Inner Flue	38mm min.
	Overlap
INTERIOR	EXTERIOR
Figure 28. Venting through the Wall

•The termination kit should pass through the wall firestops from the exterior of the building.

•Adjust the termination cap to its final exterior posi- tion on the building and interlock the flue sections.

!WARNING: THE TERMINATION CAP MUST BE POSITIONED SO THAT THE ARROW IS POINTING UP.

•Use a high-temperature sealant gasket to seal be- tween the pipe and exterior firestop.

Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. B • 7/06 21