When Full Indicator is Lit (Resetting Disk End)

8FULL Indicator

The FULL indicator will light up when STOP is set to DISK END MODE, provided that the disk space nears the end.

To reset it, do the following.

8DISK END Setup

1.Hold down the [STOP] button for 2 seconds to open the

MAIN MENU.

WJ-HD220 MAIN MENU

TIMER

 

OFF

REC SETUPO

 

EXT REC

SETUPO

 

DISPLAY SETUPO

 

SYSTEM SETUPO

 

ALARM SETUPO

 

COMMUNICATION SETUPO

SWITCHER SETUPO

 

SYSTEM INFORMATIONO

LANGUAGE

 

ENGLISH

When Error Indicator is Lit

Refer to your dealer for servicing when this happens.

8HDD Check

The recorder checks the hard disk when the recorder is turned on, or when the HDD CHECK time specified in the menu setup comes during operation.

The recorder warns you of any error detected as fol- lows.

Error indicator blinks.

Warning Out terminal on the rear panel turns active.

"HDD ERROR" will appear when there is no disk installed in the recorder.

HDD ERROR

2.Select SYSTEM SETUP, and press the JogDial to open the SYSTEM SETUP menu.

SYSTEM SETUP

(1 OF 2)

PASSWORD LOCK

OFF

ALL

*****

OPERATION

*****

KEYLOCK BUZZ

OFF

SKIP ALM-RECALL

5PAGE

SIMUL REC&PLAY

ON

ALTER DETECT

OFF

DISK END MODE

CONTINUE

DISK END BUZZ

ON

3.Move the cursor to DISK END MODE, and rotate the JogDial to select CONTINUE. Then press the JogDial.

STOP: Stops recording at the disk end.

CONTINUE: Overwrites from the start of the disk.

4.Press the [STOP] button to return to the MAIN MENU.

5.Hold down the [STOP] button for 2 seconds to return to normal operations.

The recorder starts operating in continuous mode up to the disk end.

If you wish the recorder to revert to STOP for DISK END MODE, repeat above steps 1 through 5, but select STOP in step 3.

When this happens, turn off the power. New disk(s) should be installed on the recorder, referring to INSTALLATION.

8When Error Detected

1.Turn off the recorder, and turn it on again. It will perform as follows.

DISK MENU is displayed. Error indicator blinks.

Buzzer beeps every 5 seconds.

2.Press any buttons other than [STOP] to stop the indica- tor blinking and buzzer beep.

3.See DISK MENU on the next page for further opera- tions.

95

Page 95
Image 95
Panasonic WJ-HD220 manual When Full Indicator is Lit Resetting Disk End, When Error Indicator is Lit