q | e |
* | w |
|
r |
CAM1
Notes:
•Areas adjacent to the time and date display will be excluded from VMD when TIME&DATE EMB is set to ON. Set it to OFF when you need to include these areas.
•VMD should be used when the input to the unit is from an ordinary camera. Select [OFF] to avoid use- less VMD when a video multiplexer or combination camera supplies the input to the unit.
•Set ALARM SUSPEND to ON when you do not want VMD to be activated during the VMD setup.
•There may be cases where VMD does not suffi- ciently detect changes, since it detects the changes in luminance.
•The detection area may include areas slightly out- side the border.
•The buzzer will beep if detection takes place during the area setup.
4.Set the
REW/FF |
|
/ |
|
STEP |
|
/ |
|
PUSH • PAUSE | SET |
/ | / |
5.Press the JogDial to enter the
6.Set the
7.Press the JogDial. The area is highlighted.
Up to 4 areas can be selected. These may partially overlap. Repeat steps 3 to 6 to select more areas. To deselect an area, move the cursor to the
■Communication Setup
(COMMUNICATION SETUP)
Communication parameters are set to match those of the connected devices and the system configuration. The serial port setup and network setup are made.
COMMUNICATION SETUP
SERIAL PORT SETUPO
NETWORK SETUPO
■Serial Port Setup
(SERIAL PORT SETUP)
The SERIAL PORT SETUP menu appears when it is select- ed in the COMMUNICATION SETUP menu.
SERIAL PORT SETUP
PROTOCOL |
| PS.DATA |
BAUD RATE |
| 9600 |
DATA BIT |
| 8 |
PARITY CHECK | NONE | |
STOP BIT |
| 1 |
WAIT TIME |
| OFF |
ADDR | 1 | |
ADDR | 1 | |
ALARM DATA | 1S | |
CAMERA SYSTEM | SETUPO | |
Note: Parameters marked with * on the following pages are default settings applicable to
●Protocol (PROTOCOL)
1.Move the cursor to PROTOCOL with the [D] or [C] but- ton.
2.Select a suitable protocol with the JogDial, and press the JogDial.
The default is PS• DATA.
38
