Panasonic WJ-HD220 manual Switcher Setup Switcher Setup

●HTTP Port (HTTP PORT)

Set an HTTP port number.

The default is 80.

Available port numbers: From 00000 to 65535, except the "well-known port" numbers assigned by IANA (Internet Assigned Numbers Authority)

●Dynamic Host Configuration Protocol (DHCP)

Dynamic Host Configuration Protocol is enabled or dis- abled.

The default is OFF.

Note: When ON is selected, you cannot enter the IP address, netmask, or gateway. The host gives these parameters.

The given parameters will be displayed after getting the IP address from the DHCP server.

●IP Address (IP ADDR)

The default is "192.168.000.010".

●Netmask (NETMASK)

The default is "255.255.255.000".

●Gateway (GATEWAY)

The default is "192.168.000.001".

■Switcher Setup (SWITCHER SETUP)

SWITCHER SETUP

START	DISPLAY
MULTI	OUT	QUAD-4A
SPOT	OUT	1CH
MULTI	SEL MODE	ALL
SEQUENCE SETUPO
CAMERA	VIEW SETUPO
SECRET	VIEW	OFF

Video switcher functions are programmed in this menu setup.

●Start Display (START DISPLAY)

The image in the selected form will be displayed on the multiscreen monitor and spot monitor when the recorder is turned on.

The default is QUAD-4A for MULTI OUT and 1 for SPOT OUT.

Single image: CH 1 to CH 8*

Quad image: QUAD-4A (including 1-4), QUAD-4B (including 5-8)

Multi image: 9SCREEN (including 1-8)

Sequence: SPOT SEQ*, MULTI SEQ

Note: The spot monitor can display only CH 1-8* and SPOT SEQ* while the multiscreen monitor can dis- play all forms listed above.

●Multiscreen Selection (MULTI SEL MODE)

When pressing the [MULTI SCREEN SEL] button on the front panel, the monitor display will change as follows depending on the setup.

QUAD ONLY: QUAD-4A → QUAD-4B → QUAD-4A

ALL: QUAD-4A → QUAD-4B → 9SCREEN → QUAD-4A

●Sequence Setup (SEQUENCE SETUP)

	SEQUENCE SETUP
MULTI	SEQ	SETUPO
SEQUENCE		TIMING	INT
AUTO	SKIP		ON
SPOT SEQ SETUPO
SEQUENCE		TIMING	INT
AUTO	SKIP		ON

1.Move the cursor to SEQ SETUP in the SWITCHER SETUP menu, and press the JogDial.

The SEQUENCE SETUP menu opens.

2.Select either MULTI SEQ SETUP or SPOT SEQ SETUP with the [D] or [C] button, and press the JogDial. The selected menu opens.

41