Panasonic WJ-HD220 Baud Rate Baud Rate, Data Bit Data BIT, Wait Time Wait Time, Stop Bit Stop BIT

PS• DATA: Select when the communication chain uses the PS• DATA protocol.

This selection enables the DATA terminal on the rear panel for communication.

RS-232C:Select when a protocol other than PS• DATA is used.

This selection enables the RS-232C terminal on the rear panel for communication.

Note: Parallel use of the DATA and RS-232C terminals is not possible.

●Baud Rate (BAUD RATE)

1.Move the cursor to BAUD RATE with the [D] or [C] but- ton.

2.Select the rate with the JogDial, and press the JogDial. The default value is 9600 bits per second.

4800: 4 800 bps

9600: 9 600 bps*

19200: 19 200 bps

●Data Bit (DATA BIT)

1.Move the cursor to DATA BIT with the [D] or [C] but- ton.

2.Select the bit length with the JogDial. The default value is 8 bits.

7:7 bits* ; select when using RS-232C protocol.

8:8 bits

●Wait Time (WAIT TIME)

The unit retransmits data after waiting the specified time if there is no response from the connected device.

1.Move the cursor to WAIT TIME with the [D] or [C] but- ton.

2.Select the waiting time with the JogDial. The default is OFF.

OFF: Retransmission is disabled. *

100MS: 100 m seconds

200MS: 200 m seconds

1S: 1 second

●Control Unit Address (CTL-UNIT ADDRESS) (only for PS •DATA)

When the recorder performs as a controller in the system, the unit address can be set from the setup menu on the monitor.

1.Move the cursor to CTL-UNIT ADDRESS with the [D] or [C] button.

2.Select the address with the JogDial. The default value is 1.

Assignable address: From 1 to 99, must be unique in the chain.

Note: Assign an address except 1 to WJ-HD220 when using a system controller in the system.

●Parity Check (PARITY CHECK)

1.Move the cursor to PARITY CHECK with the [D] or [C] button.

2.Select the check mode with the JogDial. The default is NONE.

NONE: No parity check

EVEN: Even parity

ODD: Odd parity*

●Stop Bit (STOP BIT)

1.Move the cursor to STOP BIT with the [D] or [C] but- ton.

2.Select the number of stop bits with the JogDial. The default is 1.

1:1 bit*

2:2 bits

●System Unit Address (SYS-UNIT ADDRESS) (exclusive to PS • DATA)

When the recorder performs as a system unit, the unit address can be set from the setup menu on the monitor.

1.Move the cursor to SYS-UNIT ADDRESS with the [D] or [C] button.

2.Select the address with the JogDial. The default value is 1.

Assignable address: From 1 to 99, must be unique in the chain.

39