Hearth and Home Technologies CD4236R, CD4842ILR, CD4842LR For Your Safety Read Before Lighting

		FOR YOUR SAFETY READ BEFORE LIGHTING								This appliance needs fresh air for safe operation
										adequate combustion and ventilation air.
										and must be installed so there are provisions for
				WARNING:	If you do not follow these instructions exactly, a fire					This appliance must be installed in accordance with
					or explosion may result causing property damage,
										local codes, if any; if not, follow ANSI Z223.1 or, in
					personal injury or loss of life.					Canada, current CAN/CGA-B149.
	A.	This appliance is equipped with an ignition device which					• If you cannot reach your gas supplier, call the fire			This appliance must be properly connected to a
		automatically lights the pilot. Do not try to light the pilot by					department.			venting system in accordance with the
		hand.				C.	Use only your hand to push in and move the gas control			manufacturer's installation instructions.
	B.	BEFORE LIGHTING smell all around the appliance area for
										WARNING: Improper installation,
							lever or knob will not move by hand, don't try to repair it, call
		gas. Be sure to smell next to the floor because some gas is					valve or turn the gas control knob. Never use tools. If the
		heavier than air and will settle on the floor.					a qualified service technician. Force or attempted repair may			adjustment, alteration, service or maintenance can
		WHAT TO DO IF YOU SMELL GAS
							result in a fire or explosion.			cause injury or property damage. Refer to the
		• Do not try to light any appliance.				D.	Do not use this appliance if any part has been under water.			owner's information manual provided with the
		• Do not touch any electric switch; do not use any phone in					Immediately call a qualified service technician to inspect the			appliance. For assistance or additional information
		your building.					appliance and to replace any part of the control system and			consult a qualified installer, service agency or the
		• Immediately call your gas supplier from a neighbor's					any gas control which has been under water.			gas supplier.
		phone. Follow the gas supplier's instructions.
Heatilator•										CAUTION: Hot while in operation. Do
				LIGHTING INSTRUCTIONS
										gasoline and other liquids having flammable vapors
										not touch. Keep children, clothing, furniture,
										away.
Caliber	1.	STOP! Read the safety information above on this label.				5.	Wait five minutes to clear out any gas. If you then smell gas, STOP!
										WARNING RISK OF FIRE
	2.	lowest setting.					smell gas, go to the next step.
		Turn wall switch to the "OFF" position or thermostat to the					Follow "B" in the safety information above on this label. If you don't
CD	3.	Turn off all electric power to the appliance.				6.	To turn on the burner, turn on all electric power to this appliance and			This appliance is intended to burn a specified gas
	4.	This appliance is equipped with an ignition device which					turn on the wall switch or set the thermostat to the desired setting.			fuel only. Do not attempt to use with solid wood fuel
Series•		automatically lights the pilot. Do NOT try to light the pilot by				7.	If the appliance will not operate, follow the instructions "TO TURN OFF			or another type of fuel. Do not attempt to modify or
		hand.					GAS TO APPLIANCE" and call your service technician or gas supplier.			use any other type of gas burner system.
4040-			TO TURN OFF GAS TO APPLIANCE							WARNING: Disconnect the electric power
										supplied with the appliance must be replaced, it must
										before servicing. If for any reason the original wire
263	1.	Turn off wall switch or set thermostat to lowest setting.				3.	Push the gas control lever in and move to the "OFF" position			be replaced with 105° C or its equivalent.
										For use with natural gas or propane. A conversion kit
Rev N	2.	Turn off all electric power to the appliance if service is to be					or push the gas control lever to the "OFF" position. Do not
		performed.					force.			as supplied by the manufacturer shall be used to
						4.	Replace the control access panel.			convert this appliance to the alternative fuel.
•									* Also certified for installation in a bedroom or a
11/08
										bed-sitting room.
									*	For U.S. only!
	Due to high surface temperatures, keep children, clothing and furniture away.										NATURAL GAS
	Keep burner and control compartment clean. See installation and operating instructions accompanying the appliance.							33631D

11

•	• •		I.
If your fireplace must be deactivated for service or an extended period of time, follow the instructions below.	The IPI system may be operated with two D-cell batteries. When using batteries, unplug the transformer. battery life, remove them when using the transformer.	For normal use, activate/deactivate your fireplace with the wall switch or remote control.	Lighting Instructions (IPI)
	To prolong