8Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the firebox.
B. Top and Rear Vent Conversion
KIT CONTENTS: Rear vent grill; .096 NG orifice; .059 LP orifice; Rear Vent Cover Plate, Top Grill Cover Plate
TOOLS REQUIRED: Power drill; #2 Phillips bit; 5/32 in. Allen wrench; 5/8 in. open end wrench;
1. Convert to Rear Vent
At the REAR of the appliance:
Outer Flue | Damper Adjustment |
Cover | Plate |
Rear
Access
Plate
Figure 8.2 Remove the rear outer flue cover plate (with the damper adjustment plate attached). Ensure that the gaskets and grommets stay in place.
Remove the inner flue cover plate and set aside.
At the TOP of the appliance, with exceptions noted:
Figure 8.1 Remove rear access plate on the back shield and
discard.Figure 8.3 Lift out the cast insert piece on top of the appli- ance.
CAUTION
Sharp Edges
•Wear protective gloves and safety glasses during installation.
Remove the outer flue collar and inner collar adapter, and set aside. Ensure that the gasket is intact; if not, high temperature silicone can be used as an alternative to gasket replacement as indicated in Figure 8.4 on the next page. Remove the screws retaining the inner flue collar.
Lift out the inner flue collar with damper in place.
NOTE: In the Commonwealth of Massachusetts, the word damper shall be replaced with the words flue restrictor.
September 1, 2008 | Page 29 |