H. Mineral Wool
WARNING
Explosion Risk.
•Follow ember placement instructions in manual.
•Do NOT place embers directly over burner ports.
•Replace ember material annually.
Improperly placed embers interferes with proper burner operation.
Figure 8.21 Place individual pieces of embers in front of and around the gas log where they can be seen. Space them so that gas can contact them on all sides. Avoid stacking the embers on top of each other.
NOTE: Do not block gas ports.
I. Glass Door Assembly Installation
J. Blower Installation
FROM THE KIT YOU WILL NEED: Blower motor; snap disc bracket with wire harness; rheostat, rheostat nut; knob; screws; 1
TOOLS REQUIRED: #2 Phillips head bit; hand drill; 11/16 in. wrench.
Figure 8.22 Mount blower to rear of the appliance using two screws.
|
| Ensure | |
|
| these | |
|
| wires are | |
Blower |
| BEHIND | |
| the | ||
mounting | Wire Harness | mounting | |
bracket | bracket. | ||
Connector | |||
beneath |
| ||
|
| ||
appliance | Blower from front |
| |
as seen |
| ||
view beneath |
| ||
from front. |
| ||
appliance. |
| ||
|
|
Remove the glass door assembly by opening latches at the bottom front of the appliance, on both the left and right sides. Lift out and away from the appliance.
Replace with a new glass door assembly.
CAUTION
Handle glass assembly with care.
•Inspect the gasket to ensure it is undamaged.
•Inspect the glass for cracks, chips or scratches.
•Do NOT strike, slam or scratch glass.
•Do NOT operate appliance with glass door removed, cracked, broken or scratched.
•Replace glass assembly as a complete assembly.
Figure 8.23 Beneath the appliance from its front side, ensure that all wiring is moved behind the blower mounting bracket which already comes installed on the bottom of the appli- ance. Complete blower mounting by inserting two screws through the blower into the mounting bracket. Make the wire harness connection.
Page 34 |
| September 1, 2008 |