F. Hearth Legs Installation
NOTE: HEARTH LEGS CANNOT BE USED IF A BLOWER IS INSTALLED AS THERE WILL NOT BE ENOUGH CLEARANCE.
Refer to Section 12 for specific color part numbers.
Hearth legs will allow three additional inches of clearance. Be sure to calculate this distance correctly if necessary to cut wall hole to install horizontally. Refer to Dimensions on in Section 12.
To change legs, use a 1/2 in. wrench to remove and replace one leg at a time while the appliance is in an upright position.
Figure 8.19 Set the rear log on the three locator pins in the back of the firebox.
G. Positioning the Logs
While still breakable, the logs do not become fragile until after the appliance is burned and they have cured. After curing, any handling must be done with care as breakage can easily occur.
PLEASE NOTE: Logs have been designed to work specifically with the burner of this appliance. Exact placement will ensure proper operation of your gas appliance and reduce sooting.
2 | 3 | 4 |
|
1
5
Figure 8.20 Set left and right partial logs (with butt end towards the side of the appliance firebox) in the grooves provided on the burner surface.
Locate the pin hole on the bottom of the right and left twigs and situate them over the white pins, one is located on the rear log and the other is on the right partial log.
Figure 8.18 The log set is packed in the components box and consists of the following:
Qty. | Description | # |
1 | Rear Log | 3 |
1 | Left Partial Log | 1 |
1 | Right Partial Log | 5 |
1 | Left Twig | 2 |
1 | Right Twig | 4 |
September 1, 2008 | Page 33 |