Figure 8.24 Use two screws to connect the snap disc bracket to the blower mounting bracket.
Route the wires from the snap disc to the right, upper edge of the blower.
Figure 8.25 Insert the rheostat control into its opening from beneath the control panel. Fit the rheostat nut on top and tighten the nut using an 11/16 in. wrench. Attach the black knob.
Gather any excess in the wiring and zip-tie to the switch wires and piezo wire at the rear of the appliance.
NOTE: This blower utilizes a snap disc to control ON and OFF operation. When the correct temperature is reached, the blower will automatically turn ON. Use the rheostat knob to adjust the fan to High or Low to suit your preferences.
September 1, 2008 |
| Page 35 |