Baxi Potterton BBU 15 HE manual GAS Boiler System Commissioning Checklist

GAS BOILER SYSTEM COMMISSIONING CHECKLIST

This Commissioning Checklist is to be completed in full by the competent person who commissioned the boiler as a means of demonstrating compliance with the appropriate Building Regulations and then handed to the customer to keep for future reference.

Failure to install and commission this equipment to the manufacturer’s instructions may invalidate the warranty but does not affect statutory rights.

Customer Name

Address

Boiler Make and Model Boiler Serial Number Commissioned by (print name) Company Name

Company Address

Telephone Number

Gas Safe Register licence No. Telephone Number

Commissioning Date

To be completed by the customer on receipt of a Building Regulations Compliance Certificate*:

Building Regulations Notification Number (if applicable)

CONTROLS Tick the appropriate boxes
Time and Temperature Control to Heating	Room Thermostat and		Programmable		Load/Weather			Optimum Start
	Programmer/Timer	Room Thermostat			Compensation					Control
Time and Temperature Control to Hot Water			Cylinder Thermostat and Programmer/Timer				Combination Boiler
Heating Zone Valves					Fitted			Not Required
Hot Water Zone Valves					Fitted			Not Required
Thermostatic Radiator Valves					Fitted			Not Required
Automatic Bypass to System					Fitted			Not Required
Boiler Interlock									Provided
ALL SYSTEMS
The system has been flushed and cleaned in accordance with BS7593 and boiler manufacturer’s instructions										Yes
What system cleaner was used?
What inhibitor was used?							Quantity				litres
CENTRAL HEATING MODE Measure and Record:
Gas Rate				m3/hr	OR						ft3/hr
Burner Operating Pressure (if applicable)				mbar	OR	Gas Inlet Pressure					mbar
Central Heating Flow Temperature											°C
Central Heating Return Temperature											°C
COMBINATION BOILERS ONLY
Is the installation in a hard water area (above 200ppm)?							Yes			No
If yes, has a water scale reducer been fitted?							Yes			No
What type of scale reducer has been fitted?

DOMESTIC HOT WATER MODE Measure and Record:
Gas Rate	m3/hr	OR
Burner Operating Pressure (at maximum rate)	mbar	OR Gas Inlet Pressure (at maximum rate)
Cold Water Inlet Temperature
Hot water has been checked at all outlets		Yes	Temperature
Water Flow Rate

ft3/hr

mbar

°C

°C

l/min

CONDENSING BOILERS ONLY

The condensate drain has been installed in accordance with the manufacturer’s instructions and/or BS5546/BS6798 Yes

ALL INSTALLATIONS

If required by the manufacturer, record the following CO2

% OR CO

ppm OR CO/CO2 Ratio

The heating and hot water system complies with the appropriate Building Regulations	Yes
The boiler and associated products have been installed and commissioned in accordance with the manufacturer’s instructions	Yes
The operation of the boiler and system controls have been demonstrated to and understood by the customer	Yes
The manufacturer’s literature, including Benchmark Checklist and Service Record, has been explained and left with the customer	Yes
Commissioning Engineer’s Signature
Customer’s Signature

(To confirm satisfactory demonstration and receipt of manufacturer’s literature)

*All installations in England and Wales must be notified to Local Authority Building Control (LABC) either directly or through a Competent Persons Scheme. A Building Regulations Compliance Certificate will then be issued to the customer.

42

©Heating and Hotwater Industry Council (HHIC) www.centralheating.co.uk