Hearth and Home Technologies SANTAFE-B1 Cleaning Firepot with Cleaning Rod & Firepot Scraper

Santa Fe Pellet Stove

R

2.Cleaning Firepot with Cleaning Rod & Firepot Scraper

•Frequency: Daily or more often as needed

•By: Homeowner

a.The appliance must be in complete shutdown and cool and the exhaust blower off. If you are just cleaning the firepot, there is no need to unplug the appliance.

b.Pull firepot cleaning rod OUT a couple of times to help shake debris loose. If rod is hard to pull, it may be necessary to use your firepot clean-out tool to chip away material that has built up on the bottom plate of the firepot and to push out any clinkers. Larger clinkers may have to be removed from the top of the firepot. Corn clinkers can be especially difficult to break up.

c.The firepot floor plate must be fully closed when finished. Figure 24.1 on page 24.

WARNING

Fire Risk

•NEVER pull firepot cleaning rod or cleaning slide plates out when appliance is operating.

•The cleaning slide plates must be fully CLOSED when appliance is operating.

•.Hot pellets may fall into ashpan and start a fire or mis-starts due to lack of vacuum.

3.Ash Removal from Firebox

•Frequency: Weekly or more frequently depending on ash build-up.

•By: Homeowner

a.Allow the appliance to completely cool down. There must not be any hot ashes in the firebox during cleaning. Turn the thermostat on and then immediately off to start the exhaust blower on its cycle time. It will pull fly ash out the exhaust instead of into the room.

b.Frequent cleaning of the ash in the firebox will help slow down the build-up of ash in the exhaust blower and vent system.

c.Open cast hinged face. Directly underneath the firebox door and to the left and right of the firepot are 2 cleaning slide plates. Pull both slide plates out and then open the glass door. Sweep the remaining ash from the firebox into the 2 open holes. A paint brush works well for this. Close slide plates.

c.Directly underneath the firebox door and to the left and right of the firepot are 2 cleaning slide plates. Pull both slide plates out and then open the glass door. Sweep the remaining ash from the firebox into the 2 open holes. A paint brush works well for this. Close slide plates.

d. This ash is deposited in the same ash pan as the firepot debris. The ash pan should be emptied every time you clean the firebox. Remember to place the ash and debris into a metal or non-combustible container. See Disposal of Ashes.

WARNING

Fire Hazard.

•The cleaning slide plates must be fully CLOSED when appliance is operating. Hot pellets may fall into ashpan and start a fire.

4.Cleaning Ash Pan

•Frequency: Weekly or every 5 bags of fuel

•By: Homeowner

Locate the ash pan underneath the firepot. Open the bottom ash door and slide the ash pan straight out. Empty into a non-combustible container and re-install ash pan. See Disposal of Ashes.

5.Disposal of Ashes

•Frequency: As needed

•By: Homeowner

Ashes should be placed in a metal container with a tight-fitting lid. The closed container of ashes should be placed on a non-combustible floor or on the ground, well away from all combustible materials, pending final disposal.

If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have been thoroughly cooled.

WARNING

Disposal of Ashes

•Ashes should be placed in metal container with tight fitting lid.

•Ashes should be retained in closed container until all cinders have thoroughly cooled.

September 1, 2008 7001-142D Page 29