Hearth and Home Technologies SANTAFE-B1 owner manual

Page 27

Santa Fe Pellet Stove

R

Symptoms

Possible Cause

Corrective Action

Convection blower fails to

#1 snap disc defective.

Replace snap disc.

start.

Blower not plugged in.

Check that blower is plugged into wire har-

 

 

 

ness.

 

Blower is defective.

Replace blower.

 

Control box is defective.

Replace control box.

Exhaust blower fails to

Blower not plugged in.

Check that blower is plugged into wire har-

start or does not shut off.

 

ness.

 

Blower is clogged with ash.

Clean exhaust system.

 

Blower is defective.

Replace blower.

 

Control box is defective.

Replace control box.

Large, lazy flame, orange

Dirty appliance.

Clean unit, including firepot, heat exchang-

color. Black ash on glass.

Poor fuel quality, high ash content.

ers and venting system. Remove stainless

 

 

steel baffle from firebox to clean ash from

 

 

on top of baffle. Clean behind rear brick

 

 

panels. Change fuel brand to premium.

 

Firepot clean-out plate not completely

Check that firepot clean-out plate is fully

 

closed.

closed.

 

 

Reduce feed rate using feed rate adjustment

 

Excessive amount of fuel.

control rod located inside hopper.

Nuisance shutdowns.

Low flame.

Increase feed by opening feed rate adjust-

 

 

ment control rod located inside hopper.

 

Sawdust buildup in hopper.

Clean hopper, see page 30.

 

Feed motor is reversing.

Check for good connections between feed

 

 

motor and wire harness.

 

Defective thermocouple.

Replace thermocouple.

 

Defective control box.

Replace control box.

 

Firepot more than 1/2 full.

See page 32 for detailed instructions for

 

 

“High Ash Fuel Content Management”

Appliance calls for heat.

Thermocouple is defective or not properly

Check connections on thermocouple or

Call light illuminates.

plugged in.

replace if defective.

Exhaust blower starts.

 

A flashing yellow light on the control box

No feed or igniter.

 

indicates a problem with the thermocouple.

 

Defective control box

Replace control box.

September 1, 2008

7001-142D

Page 27

Image 27
Contents Santa FE Pellet Stove Santa Fe Pellet Stove Serial Number Model NameLocation Back side of left side panel Table of Contents Listing and Code Approvals Thermostat Location Design, Installation & Location Fire Safety ConsiderationsGetting Started Appliance LocationInspect Appliance & Components and Pre-Use Check List Santa Fe Pellet Stove Tools And Supplies NeededAppliance Dimensions 3Dimensions and ClearancesSanta Fe Pellet Stove Clearances to Combustibles UL and ULC Exception for Horizontal Installations Santa Fe Pellet Stove Hearth Pad Requirements UL and ULCHearth Pad Requirements Venting Termination Requirements Chimney and Exhaust ConnectionPipe Selection Chart Santa Fe Pellet Stove Equivalent Feet of PipeExample of 3 Elbow-Rear Vent Termination Calculaton Alcove Venting SystemsStraight Out DegreeSanta Fe Pellet Stove Through The Wall Through The Wall & Vertical Santa Fe Pellet Stove VerticalAlternate Masonry MasonryMobile Home Outside Air Kit Instructions 7Appliance Set-UpSanta Fe Pellet Stove Top Vent Adapter Installation Rear Vent and Rear Vent to Top Vent Adapter InstallationInstalling the Top Vent Adapter Notch Thermocouple Cover Installing the Grille Installing the Trim RingIncluded in Kit 1 Grille Santa Fe Pellet Stove Thermostat Installation Fuel Size And Material General Operating Information Operating InstructionsSanta Fe Pellet Stove Before Your First Fire Fire CharacteristicsFeed Rate Adjustment Instructions Feed Adjustment Control Rod Wing Nut Set ScrewSanta Fe Pellet Stove Iginition Cycles Frequently Asked QuestionsTroubleshooting SymptionPossible Cause Corrective Action Page Page Types of Fuel Quick Reference Maintenance ChartMaintaining & Servicing Your Appliance Frequency Daily Weekly Monthly YearlyDisposal of Ashes Frequency As needed Cleaning Firepot with Cleaning Rod & Firepot ScraperCleaning Ash Pan Ash Removal from FireboxCleaning the Exhaust Path Cleaning Heat Exchanger Chambers & Drop TubeCleaning Beneath Heat Exchanger Cleaning Beneath Heat Exchanger Cont’dDoor Latch Inspection Cleaning the GlassCleaning Exhaust Blower Requires No Lubrication Cleaning Convection Blower Requires No LubricationImmediate Attention and Cleaning is Required Santa Fe Pellet Stove High Ash Fuel Content MaintenanceExhaust Blower Replacement Convection Blower ReplacementWing Nut Snap Disc #2 ReplacementIgniter Replacement Baffle & Brick Replacement Glass Replacement Reference Materials Snap Disc #2 Fuel Delivery Interrupt 250F Vacuum SwitchWiring Harness See .1 below Snap Disc #1 Convection Blower 110FSanta Fe Pellet Stove Component Locations Description Part Number Santa Fe Pellet Stove Exploded ViewsDescription Nbr Item # Service Parts Description Part Nbr Santa Fe Pellet Stove Service Parts and AccessoriesLVGRL-SF-NL Accessory Description Part NumberDate of Service Performed By Description of Service Santa Fe Pellet Stove Service And Maintenance LogCONDITIONS, Exclusions & Limitation of Liability Santa Fe Pellet Stove Warranty PolicyHearth & Home Technologies Limited Warranty Cont’d Telephone Contact Information