Hearth and Home Technologies SANTAFE-B1 Santa Fe Pellet Stove Top Vent Adapter Installation

R

Santa Fe Pellet Stove

B. Top Vent Adapter Installation

3 to 3 inch Top Vent Adapter

3 to 6 inch Top Vent Offset Adapter

Installing the Top Vent Adapter

1.Put a layer of high temperature silicone on the 3 inch (76mm) exhaust outlet. Figure 18.1

2.Slide the top vent adapter onto the rear exhaust outlet and adjust the assembly to a vertical position.

Figure 18.1

3.Drill 4 holes with #26 drill bit (provided) into the back of the appliance using the outer shield as a pattern (make sure the assembly is vertical).

Figure 18.2

4.Install the 4 mounting screws.

5.Drill 2 holes with #26 drill bit through the rear exhaust outlet using the 2 holes already in the short horizontal pipe in the top vent adapter as a guide. Install the 2 screws. Figure 18.1

6.Install the vent pipe into the top vent adapter (be sure to silicone all joints).

7.To clean the top vent adapter open the clean-out cover. Figure 18.2.

Drill holes in back of stove and secure with 4 screws, 2 on each side

Clean-Out Cover

Figure 18.2

C.Rear Vent and Rear Vent to Top Vent Adapter Installation

Clean-Out Cover

Silicone

Rear Exhaust

Outlet

 to 6 in. Offset Adapter

 to  in. Top Vent Adapter

Use hole on each side as

drilling guide

Figure 18.1

Figure 18.3 - Rear Vent Adapter

Clean-Out Cover

Figure 18.4 - Rear to Top Vent Adapter - 90o

1.Put a layer of high temperature silicone on the 3 inch (76mm) exhaust outlet. Figure 18.1.

2.Slide the adapter onto the rear exhaust outlet and adjust the assembly to the appropriate position.

3.Install the vent pipe into the adapter (be sure to silicone all joints)

Page 18 7001-142D September 1, 2008