Hearth and Home Technologies SANTAFE-B1 Installing the Grille, Installing the Trim Ring

R

Santa Fe Pellet Stove

E.Optional Gold or Nickel Grille & Trim Ring

1.Installing the Grille

Included in Kit: (1) Grille

Tools Required: Phillips head screwdriver

1. While holding door to face, remove 2 screws from grille and remove existing grille. Figure 20.1.

2.Install new grille using screws removed in step 1. Ensure that screws are inserted through the grille, rib and door.

Remove 2 screws

Grille

Face Rib

Door

Rib

Locating screws on rib are the 2 outside holes on each side

Figure 20.1

2.Installing the Trim Ring

Included in Kit: (1) Trim Ring, (6) 8-32 nuts

Tools Required: Phillips head screwdriver, 11/32” wrench or nut driver

1.Face can be removed with the door on or off the appli- ance. Remove the grille before removing face to prevent it from falling foward and potentially causing damage.

2.Tilt the top of the face foward until the top rib clears the door, then slide the face down until the locating screws on the bottom rib are completely out of the door.

Figure 20.2.

3.Lay the face, face-down on a protective coating to avoid scratching.

4.Remove the 6 nuts from the back side of the face and discard the stud and nuts.

5.Turn the face over so it is front side up. Locate studs on the trim ring. Starting with one straight side of trim ring, insert the studs into the holes in the face. After the first 2 studs have dropped into their holes, carefully lay the trim ring down until all of the studs are in place.

Figure 20.3.

6.Hold the trim ring in place and turn the face over to expose the back side. Figure 20.4.

7.Place 8-32 nuts, included in the kit, on all 6 studs and gently tighten them.

8.Reverse steps 1 and 2 to re-install face and the grille.

Lift up so top rib

can clear the door

Slide face down until locating screws are out of door

Figure 20.2

Start with straight edge

Figure 20.3

Figure 20.4

Page 20 7001-142D September 1, 2008