| R | Santa Fe Pellet Stove | |
|
|
|
|
|
|
|
|
| 1 Listing and Code Approvals |
|
|
|
|
|
|
A. Appliance Certification
Model: | Santa Fe Pellet Stove |
Laboratory: | OMNI Test Laboratories, Inc. |
Report No. | |
Type: | Solid Fuel Room Heater/Pellet |
| Fuel Burning Type |
Standard: | ASTM |
| |
| M1990 Room Heater Pellet Fuel |
| Burning type and (UM) |
| Mobile Home Approved. |
State of Colorado: | Listed |
B. Mobile Home Approved
This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is provided. The structural integrity of the mobile home floor, ceiling, and walls must be maintained. The appliance must be properly grounded to the frame of the mobile home and use only listed pellet vent Class “L” or “PL” connector pipe. A
E. BTU & Efficiency Specifications
Particulate Emis- | 0.7 grams/hr | |
sions Rating: | ||
| ||
*BTU Output: | 8,000 - 30,000 / hr | |
Heating Capacity: | up to 1,500 sq. ft. depending | |
| on climate zone | |
Hopper Capacity: | 52 lbs | |
Fuel: | Wood Pellets or Shelled Corn | |
Shipping Weight: | 240 lbs |
*BTU output will vary, depending on the brand of fuel you use in your stove. Consult your
NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.
C. Glass Specifications
This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.
NOTE: This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM
M1990, (UM)
D. Electrical Rating
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps
Page | September 1, 2008 |