Hearth and Home Technologies SANTAFE-B1 owner manual Notch Thermocouple Cover

Santa Fe Pellet Stove

D. Optional Log Set Placement Instructions

CAUTION

R

Logs are FRAGILE. Use extreme care when handling or cleaning logs.

NOTE:

Due to the abrasive nature of a pellet appliance fire, the logs are not covered under warranty. Any placement varia- tion other than shown here can cause excessive heat and shall void the appliance warranty.

4 PIECE LOG SET INSTALLATION

1.Place the right rear log as shown. There is a notch in the bottom of the log for clearance for the thermocouple and thermocouple cover (ceramic protection tube). Figure 19.1.

2.Continue placing the last 3 logs around the firepot as show in Figures 19.2, 19.3 and 19.4. Be careful not to block the drop tube in the back of the firebox where pel- lets feed into the firepot.

Notch

Thermocouple

Cover

Figure 19.1

Figure 19.3

Figure 19.4

OPTIONAL TOP LOG

Place the top log over the firepot. It will be about 2-1/2 inches (64mm) above the firepot when in place. Notice the position of the top log as it rests on the 3 logs in a stable position to prevent it from falling into the firepot.

The charred area on the back of the top log faces the back, not the front. Figure 19.5.

Drop Tube

Figure 19.2

Figure 19.5

September 1, 2008 7001-142D Page 19