Santa Fe Pellet Stove
R
C. Blower Replacement
1.Convection Blower Replacement
a.Turn down the thermostat, let appliance completely cool and then unplug appliance before servicing.
b.The Convection Blower is located on the floor at the rear of the appliance.
c.Remove the right lower side curtain by releasing bracket from attachment holes in the back and then swing it to the front and lift off of the appliance. When
d.Cut the tie wire holding the wires togehter and then dis- connect the yellow and purple wires.
e.
f.Attach new tie wire to hold wires together.
Remove lower
right side curtain
Back of Stove
Flex curtain and snap brackets into attachment holes
Figure 33.1
Exhaust
Blower
Convection | Pull blower up of the locating |
Blower | pins and pull towards you. |
|
Figure 33.2
2.Exhaust Blower Replacement
a.Turn down the thermostat, let appliance completely cool and then unplug appliance before servicing.
b.Remove both lower side curtains. Figure 33.1.
c.Remove the lower rear screen and lay flat, leaving all wires still attached.
d.Remove the upper rear screen from the appliance by removing 2 screws at the top, 1 in the center and 2 screws on the sides at the top. Leave both upper side curtains still hinged in place to the rear screen. Figure 33.3.
e.Remove the 2 screws holding the vacuum switch in place. Disconnect vacuum hose and blue and white wires from the vacuum switch.
f.Remove the 2 screws holding the junction box in place.
e. Disconnect the white and blue wires from the exhaust blower.
f.There is a removable plate on the exhaust blower. Using a 1/4” nutdriver loosen the 6 screws in the keyhole shaped holes and rotate the plate. Figure 33.4
g.Remove the exhaust blower and gasket.
i.
Remove 2 screws, 1 on each side | |
Junction Box | Metal Strip |
inside Hopper | |
Screws |
|
Tabs at bottom of upper rear screen | |
Lower Rear Screen | |
Figure 33.3
Figure 33.4
September 1, 2008 | Page 33 |