Santa Fe Pellet Stove
7Appliance Set-Up
R
A. Outside Air Kit Instructions
Parts Included in Kit: 1 piece of 2 inch x 3 foot flex hose,
2 hose clamps, 1 collar assembly, 1 termination cap assem- bly, 1 trim ring, 12 screws. (Discard collar assembly and air channel, collar assembly already on appliance).
Tools Needed: Phillips head screwdriver; wire cutters; hole saw or jig saw.
1.Measure distance from floor to air vent opening in stove and mark location on wall.
Use saw to cut opening in wall. Cut a
2.Use hose clamp to secure flex pipe to collar assembly.
3.Slide trim ring over flex pipe and run pipe through wall.
4.Attach hose to outside termination cap with second hose clamp.
5.Secure termination cap to outside surface.
6.Secure trim ring to interior wall.
CAUTION
Never draw outside combustion air from:
•Wall, floor or ceiling cavity
•Enclosed space such as an attic or garage
Termination
Cap Assembly
Hose Clamp |
Trim Ring
Flex Hose
Air Intake Channel
Hose Clamp
Collar Assembly
Figure 17.4
September 1, 2008 | Page 17 |