Operating Guide, Lay Out the System, Step

Petsafe RFA-200 Operating Guide, Step Locate the Fence Transmitter, Lay Out the System, Twists/ft

Operating Guide

Step Locate the Fence Transmitter

Place the Fence Transmitter:

1	• In a dry, well ventilated, protected area (1A, 1B).
	• In an area where temperatures do not fall below freezing (e.g., garage, basement, shed, closet).
	• Secured to a stationary surface using appropriate mounting hardware (not included). A mounting template is
	included on the back of this guide.
	• At least 3 feet from large metal objects or appliances as these items may interfere with the signal consistency (1C).

Once you have mounted the Fence Transmitter, the Boundary Wire must exit the building. This can be accomplished via a window or through a 1/8” hole drilled through the wall. Ensure the drill path is clear of any utilities. Make sure the Boundary Wire is not cut off or pinched by a window, door, or garage door, as this can damage it over time.

To prevent ﬁres and electrical hazards, install the Fence Transmitter in buildings that are in accordance with state and local electrical codes.

1A	1B	1C
		3ft.

__________________________________________________

Step

Lay Out the System

Basic Planning Tips

• The Boundary Wire MUST start at	2A	2B
the Fence Transmitter and make a
continuous loop back (2A).
• Design a layout that is suitable for your
yard. Sample layouts are provided in
this section, and a grid for designing

10Twists/ft.

your layout is provided on the back of this guide.

• Fence planning software is available online at www.petsafe.net. After you have planned and saved your layout online, contact our Customer Care Center to review and reﬁne your layout.

•Twisting the Boundary Wire cancels the signal and allows your pet to cross

over that area safely. Plastic or metal

piping will not cancel the signal. Twist the Boundary Wire 10 to 12 times per foot to cancel the signal (2A).

•Always use gradual turns at the corners to produce a more consistent boundary (2B). Do not use sharp turns, as this will cause gaps in your boundary.

•Avoid making passageways too narrow for your pet to move about freely (e.g., along the sides of a house).• The Receiver Collar can be activated inside the house if the Boundary Wire runs along the outside wall of the house. If this occurs, remove your pet’s Receiver Collar before bringing him inside, decrease the range using the Boundary Width Control knob or consider an alternative layout.