APC ACRD101, ACRD100 manual Semi-Annual Preventive Maintenance, Functional tests

Page 51

Quarterly Preventive Maintenance

Perform all the Monthly Preventive Maintenance items and the items below.

Prepared By: _________________________________

Model Number: _______________________________

Serial Number: _______________________________

Date: ______________________________________

Mechanical

Electrical Hazard: Turn off the cooling unit and disconnect all power sources. Perform Lockout/ Tagout procedures before performing any electrical or mechanical service. Wear appropriate personal protective equipment when checking hazardous voltages.

‰Verify that the fan hardware is tight.

‰Clean or replace the air filters.

‰Clean the condensate drain line.

‰Clean the dust from door perforations.

‰Clean the dust from fan bezels.

Functional tests

‰Verify the cooling operation mode is functioning properly.

Semi-Annual Preventive Maintenance

Perform all the Monthly/Quarterly Preventive Maintenance items and the items below. Prepared By: _________________________________

Model Number: _______________________________

Serial Number: _______________________________

Date: ______________________________________

Cleanliness

‰Check the cleanliness of the evaporator coil. Clean if required.

InRow RD 10 kW Air Cooled Operation and Maintenance

43

Image 51
Contents Operation and Maintenance 동봉된 CD 안에 한국어 매뉴얼이 있습니다 American Power Conversion Legal Disclaimer Page Contents Cooling Group Configuration Network Management Card Page Symbols used in this manual Cross-reference symbol used in this manualOverview Safety Inspection Checklists Initial inspection checklistEnsure that Electrical inspection checklist Ensure that Mechanical inspection checklistWhile the cooling unit is operating, ensure that User interface inspection checklistStart-up inspection checklist Final inspection checklistCalculating R410A charge Charging With RefrigerantInRow RD 10 kW Air Cooled Operation and Maintenance Charging the equipment Compressor Oil Charge Oil charging procedureInRow RD 10 kW Air Cooled Operation and Maintenance Display Interface OperationMain menu screens Using the Display InterfaceScrolling status screens Status Screen Name Status Information DisplayedNavigating the sub-menus Navigating the main menuUsing the Path statement Password entryStart the cooling unit General Configuration Cooling unit configurationStop the cooling unit View the state of input and output contacts Cooling Group ConfigurationConfigure the cooling group ContactsIdentify the cooling unit Configure ModbusSetpoints Control the EnvironmentPID settings Loop Behavior PID Tuning Correction Tune the PID loopControl Method Proportional Integral Derivative Service intervals Run hoursThresholds Date and time Password and time-outDisplay units Adjust display settingsConfigure network Network ConfigurationCooling unit status View Status ReadingsAbout the cooling unit Cooling group statusEvent Log View the event logClear the event log Alarm messages and suggested actions Respond to AlarmsView active alarms Clear active alarmsThreshlds screen Configure Unit Discrete I/O screen. See page 17 for more Quick Configuration TCP/IP configuration methodsOverview APC Device IP Configuration Wizard Bootp & Dhcp configurationIni file utility NetworkTCP/IPBoot ModeDHCP onlyAdvancedDHCP Cookie Is Remote access to the control console Local access to the control consoleChoose Network from the Control Console menu Control consoleWeb interface Access a Configured Network Management CardTelnet and SSH Modbus Simple Network Management Protocol SnmpRecover From a Lost Password Monthly Preventive Maintenance CleanlinessEnvironment Electrical MechanicalFunctional tests Semi-Annual Preventive MaintenanceProblem Possible Cause Corrective Action TroubleshootingCorrective Action Problem Possible CausePage Page 990-3212A-001 11/2009 APC Worldwide Customer Support