APC ACRD101 Overview, Symbols used in this manual, Cross-reference symbol used in this manual

Page 9

General Information

Overview

Note the definitions for the icons here and be observant for them throughout this manual. They are intended to call attention to potential hazards and important information.

Symbols used in this manual

Electrical Hazard: Indicates an electrical hazard which, if not avoided, could result in injury or death.

Danger: Indicates a hazard which, if not avoided, could result in severe personal injury or death.

Warning: Indicates a hazard which, if not avoided, could result in personal injury or damage to product or other property.

Heavy: Indicates a heavy load that should not be lifted without assistance.

Caution: Indicates a potential hazard which, if not avoided, could result in damage to the equipment or other property.

Tip Hazard: This equipment is easily tipped. Use extreme caution when unpacking or moving.

Note: Indicates important information.

Indicates that more information is available on the same subject.

Cross-reference symbol used in this manual

See another section of this document or another document for more information on this subject.

InRow RD 10 kW Air Cooled Operation and Maintenance

1

Image 9
Contents Operation and Maintenance 동봉된 CD 안에 한국어 매뉴얼이 있습니다 American Power Conversion Legal Disclaimer Page Contents Cooling Group Configuration Network Management Card Page Symbols used in this manual Cross-reference symbol used in this manualOverview Safety Inspection Checklists Initial inspection checklistEnsure that Electrical inspection checklist Ensure that Mechanical inspection checklistStart-up inspection checklist User interface inspection checklistFinal inspection checklist While the cooling unit is operating, ensure thatCalculating R410A charge Charging With RefrigerantInRow RD 10 kW Air Cooled Operation and Maintenance Charging the equipment Compressor Oil Charge Oil charging procedureInRow RD 10 kW Air Cooled Operation and Maintenance Display Interface OperationScrolling status screens Using the Display InterfaceStatus Screen Name Status Information Displayed Main menu screensNavigating the sub-menus Navigating the main menuUsing the Path statement Password entryStart the cooling unit General Configuration Cooling unit configurationStop the cooling unit Configure the cooling group Cooling Group ConfigurationContacts View the state of input and output contactsIdentify the cooling unit Configure ModbusSetpoints Control the EnvironmentPID settings Loop Behavior PID Tuning Correction Tune the PID loopControl Method Proportional Integral Derivative Service intervals Run hoursThresholds Date and time Password and time-outDisplay units Adjust display settingsConfigure network Network ConfigurationCooling unit status View Status ReadingsAbout the cooling unit Cooling group statusEvent Log View the event logClear the event log View active alarms Respond to AlarmsClear active alarms Alarm messages and suggested actionsThreshlds screen Configure Unit Discrete I/O screen. See page 17 for more Quick Configuration TCP/IP configuration methodsOverview APC Device IP Configuration Wizard Bootp & Dhcp configurationIni file utility NetworkTCP/IPBoot ModeDHCP onlyAdvancedDHCP Cookie Is Remote access to the control console Local access to the control consoleChoose Network from the Control Console menu Control consoleWeb interface Access a Configured Network Management CardTelnet and SSH Modbus Simple Network Management Protocol SnmpRecover From a Lost Password Monthly Preventive Maintenance CleanlinessEnvironment Electrical MechanicalFunctional tests Semi-Annual Preventive MaintenanceProblem Possible Cause Corrective Action TroubleshootingCorrective Action Problem Possible CausePage Page 990-3212A-001 11/2009 APC Worldwide Customer Support