Mitw -12 / -15 Series

TTW1 Universal Service

Replacement Blower

Step 4. Remove the screws, qty. (3), that secure the blower to the jacket head.

Unscrew (3) screws that hold

blower to the jacket head.

Blower junction box

Step 5. Disconnect blower wire harness from receptacle, located in the jacket head under the blower junction box. The white connector must be pinched to remove.

Unplug blower harness from jacket head receptacle by pinching the connector.

Step 6.	Remove the blower from the top of the
	water heater. Remove any loose debris
	and tools from the top of the water heater.

Warning:	Failure to locate the blower correctly will
	result in improper water heater operation.

Step 7.	Create the new mounting hole locations
	for the new universal replacement blower.
	Use template supplied with manual.
	a.) On the template, P/N 238-47197-00,
	the (3) circular sections for the water
	connections and flue have already
	been removed. Also, the dotted lines
	from the side of the paper are
	perforated for easy tearing.

The (3) circular sections on template have been pre-cut and removed.

Tear paper along dotted lines where perforation exists, or cut with scissors.

Page 13